Belkin High Speed ADSL2+ User manual

High Speed ADSL2+
Modem Quick Installation Guide
Setup Overview
1 Hardware Connections
Step A
Place the modem next to the computer. Connect the Modem’s power cord into the
back of the Modem. Connect a telephone cable from the wall into the back of the
Modem.
If your computer has an Ethernet (network) connection, continue with section B1.
Alternatively you can install the Modem with a USB connection, continue with section B2.
Step B1
Find your new networking cable (it came in the box with your Modem) and connect it to
the LAN port on the back of the modem.
Connect the other end to your computers LAN port.
Please continue to Step 2
Thankyou for purchasing a Belkin Modem, you will need to run through the following steps once to set up your Modem.
Hardware Connections:
Use the instructions in this Guide
to connect your Modem to your
computer.
Confi guring your
Modem:
Confi gure your Belkin Modem
with the easy-to-use Web Based
Setup Utility
Connecting to the Internet
1
2
3
It’s as easy as 1-2-3
Ethernet Setup
Step B2
Insert the CD into your computer.
Windows ME (or later) users: Connect the Modem to your computer with a USB cable.
Windows 98SE users: Please refer to the user manual located on the CD for further
instructions.
Please continue to Step 2
USB Setup






Step A
Open your Internet Browser (Internet Explorer, FireFox, Netscape, Safari etc) In
the Address Bar, type in 10.1.1.1. You will be presented with a Login screen, type in
“admin” as the password then click LOGIN
Note: The password is case sensitive.
2 Confi guring your Modem




Step B
Select your country (Australia or New Zealand)
Add your current username and password. Please confi rm with your Internet
Service Provider for the correct username, username format & password.
Click SAVE SETTINGS
© 2006 Belkin Corporation. All rights reserved. All trade names are
registered trademarks of respective manufacturers listed.
F5D5730au
Support
Belkin provides free technical
support via phone and the Web.
However, we encourage you to
attempt (or retry) Steps 1 and 2
before contacting Support.
If you’re still having trouble, contact
Belkin Support.
Web
www.belkin.com/anz
(click on Support Centre)
Phone
1800 BELKIN Aus
0800 BELKIN NZ
Monday-Friday 08:00-20:00
(Sydney time zone)
Closed public holidays
Please allow up to fi ve minutes for the ADSL Data light (a) to illuminate. This
indicates a successful connection to the Internet.
Once the ADSL Data light has illuminated, open your Web Browser and surf the
web!
Note: If the ADSL Data light is solid, this indicates a connection to the Internet
has been established.
If the ADSL Data light is fl ashing, this indicates data activity e.g. when browsing
websites etc.
3 Connecting to the Internet

Any telephone connected to the same telephone line as your ADSL modem needs
to be fi ltered. This allow you to use the Internet and talk on the phone at the
same time.
If you have a telephone connected to same socket as the Modem, you will need a
Splitter (not included) (a).
Any extra telephones that are connected to the same telephone line need an
inline fi lter (not included) (b).
Connecting telephone fi lters



(a)
(a)
(b)