Berlin Gardens 24x50 Cushion Storage Box User manual

24"x50" Cushion Storage Box Assembly Guide
32 6 16 16
Place a side against back
ensuring that all edges are
even and fasten using
4 - 2" Screws (D). Repeat
on other side.
Note: Sides
are assembled the same
there is no right or left side.
Ensure these edges are even before attaching
Step 1-Side Attachment
Fasten inside using 1-1/4" screws(C).
Repeat on other side.
Begin by laying back panel flat on floor. (Front panel should have Berlin Gardens label attached). Fasten Gas Cylinder brackets to sides
using 3-1" Screws (B) per bracket as shown. NOTE: Bracket placement has predrilled holes for screws.
Tape Measure
Hardware Included
(Included)
A.
B.
C.
D
D
C
C
Tools Needed
#2 Square Drive Bit
Cordless Drill
Side Attachment Detail
Inside Angle Attachment Detail
1-1/4" Screws
C
1" Screws
B
D
24"x50" Cushion Storage Box
Gas Cylinder Bracket x2
Gas Cylinder Bracket
B
B
Gas Cylinder x2
A
3/4" Screws 2" Screws

Step 2- Front Panel Attachment
Set front down onto sides
ensuring that all edges are
even and fasten using
4 - 2" Screws (D). Repeat on
other side.
Fasten inside following side
attachment using 1-1/4" screws (C).
Repeat on other side.
Step 3-Bottom Attachment
Insert the bottom ensuring that it
is pushed up against the aluminum
on the inside. Fasten it to the 4 sides
using 3/4" screws. (A)
Step 4-Top
Begin by setting the above assembled piece upright.
Next set the top with the hinge side towards the back
on top of the assembled piece then ensure the top is
evenly spaced on both the right and left side and fasten
the hinge to the back. Using 3/4" screws. (A)
Step 5-Gas Cylinders
A
A
D
D
C
C
A.
B.
Have one person hold open the lid while a second person pushes the bottom
of the cylinder onto bracket until you feel it click into place. To ensure
it is properly secured make sure you can not remove the cylinder by pulling
backwards on it. Push the top of the cylinder onto the bracket that is
attached to the aluminum frame and ensure it is properly secured. Repeat
on opposite side. Your Cushion Storage Box is now complete!
NOTE:
Bottom
half of cylinders are thinner than top half.
Bottom Attachment Detail
Top Hinge Fastening
Side Panel Attachment
Inside Angle Attachment