Berlin Gardens Vinyl A-Frame Firmware update

Firmly tap bolts into pre-drilled
holes before tightening.
CORRECT INCORRECT
1 2 34 5
Use to measure bolts
TOOLS NEEDED:
Hammer, ½" Wrench,
⁄" Wrench, ⁄" Wrench,
& Screw Gun
¼" x 4"
Lag Bolts
Top Beam
To avoid personal injury or
damage to your A-Frame,
assembly requires two people.
!
Long Leg Brace
Short Leg
Brace
¼" x 4"
Lag Bolts
Leg
⁄" x 5½" Machine Bolts
¼" x 4" Lag Bolts
" x 5½" Machine Bolts
" x 5½" Machine Bolts
⅜" x 7"
Machine Bolt
See
Leg/Top Beam
Inset
Leg/Top Beam
Inset
Top Brace
Top Brace
Model #VAF920
Assembly Directions for
Vinyl A-Frame
PACKAGE CONTENT
1 Top Beam
4 Legs
2 Short Leg Braces
2 Long Leg Braces
4 Top Braces
1 Hardware Package
HARDWARE PACKAGE
2 " x 7" Machine Bolts
2 " x 5 ½" Machine Bolts
20 ¼" x 4" Lag Bolts
4 ⅜" Washers
2 ⅜" Nuts
2 " Washers
2 " Flange Nuts
20 ¼" Washers
2 ⅜" NY Glides

Step #5
Step #6
Step #7
Fasten the Top Braces to the Top Beam using ⁄" x 5½"
Machine Bolts and ⁄" Washers & Flange Nuts.
Fasten the Short Leg Brace to the Top Brace
using ¼" x 4" Lag Bolts (and ¼" Washer). As
shown in the inset, ensure that the bottom of
the Short Brace is even with the bottom edge
of the Top Brace.
Install the NY Glides.
Fasten legs using ⅜"x 7" Machine Bolts and washers (on
both sides of swing). Note: Two of the legs will have ve
(5) predrilled holes (see inset). Make sure one of these legs is
located on each end of structure.
Step #1 Step #2
Tighten Nuts using a " socket and cord-
less drill.
A. Line up Braces with the predrilled holes and fasten
using ¼" x 4" Lag Bolts with a Washer.
B. In the event that your A-Frame does not include a
Vinyl A-Frame Roof, insert the two Vinyl Hole Plugs into
the extra predrilled hole.
Step #3 Step #4
Stand up your A-Frame as shown.
To avoid personal injury or
damage to your A-Frame,
assembly requires two
people.
!
Top Brace
Short Brace
¼" x 4"
Lag Bolts