Berlin Gardens Harbor User manual

Step 1
Cordless Drill
7/16" Wrench
1
4
" x 2"
Bolt x8
1
4
" Flange
Nut x8
1
1
2
" Buglehead
Screw x4
3" Buglehead
Screw
5
8
" Panhead
Screw x16
Umbrella Knob x2
Dining Height x8
Counter Height x16
Bar Height x16
Harbor Table Assembly 60" Round (Dining, Counter & Bar Heights)
Dining Height Counter Height Bar Height
Hardware Included Tools / Items Needed
Harbor Table Assembly Guide
Open the box containing the Table top on all sides
but leave the top laying in the box. Next fasten all
cross pieces to 1 base assembly by inserting
cross piece tenons into mortises on base
assembly and fasten using 3" Buglehead Screws.
Repeat assembly on other side with remaining
base assembly. NOTE: Dining Height will only
have 1 set of cross pieces.
Counter and Bar Height Only
3" Buglehead Screws
Step 1 Detail
Allen Wrench
(Included)
#2 Square Drive Bit

Step 2
Step 3
Lift base assembly over the center leg and onto the bottom
of the table top. Line up holes in base ends with holes in the
aluminum frame on the table top and attach base to frame
using 1/4"x2 Bolts and 1/4" Flange Nuts. Note: Ensure bolts
and nuts are properly secured using a wrench and supplied
Allen Wrench.
Start by placing a table brace against the bottom
of the table top and against the inside of a base
leg as shown. Fasten the brace against the leg
using 1, 1-1/2" Buglehead Screw. Next fasten the
aluminum piece against the top using 2, 5/8"
Panhead Screws. Note: The aluminum piece that
is fastened aginst the brace should be placed
against the table top.
1/4"x2" Bolts
1/4" Flange Nuts
5/8" Panhead Screws
1-1/2" Buglehead
Screws
Start by placing the center leg over the umbrella plug as
shown and fasten leg frame to bottom of table top using
8-5/8" Panhead Screws. Note: Do not over tighten screws!
Step 2 Detail
5/8" Panhead Screws
Step 3 Detail
Step 4
Step 4 Detail