Berlin Gardens ATAT1823 Firmware update

Assembly Directions for
Adirondack Chair Tete-a-Tete
#ATAT1823
STEP #1 - Fasten 1-Aluminum Bracket
to the left arm of one chair
and the right arm of the
second chair using ¾" Panhead
Screws. Slide the Bracket all
the way forward against the
front leg.
STEP #3 -
STEP # - 2 Place the Tete-a-Tete onto the angle brackets and
secure by screwing the knobs into the pre-drilled
holes in the underside of the table.
HARDWARE PACKAGE
10 ¾" Screws
4 Knobs
PACKAGE CONTENTS
1Tete-a-Tete Table
1 Hardware Package
2 Aluminum Angle Brackets
TOOLS NEEDED:
Cordless
Drill/Screwdriver
Firmly tap bolts into pre-drilled
holes before tightening.
CORRECT INCORRECT
1 2 34 5
Use to measure bolts
front leg.
Aluminum Angle Bracket

Assembly Directions for
Adirondack Chair
#PATC2400
HARDWARE PACKAGE
2 ¼" x 2½" Lag Bolts
4 ¼" x 3½" Allen Head Bolts
42½" Screws
4 ¼" Flange Nuts
1Allen Wrench
TOOLS NEEDED:
7/" Wrench
Cordless drill/Screwdriver
#2 Square Drive Bit
Allen Wrench (Included)
Hammer
PACKAGE CONTENTS
1 Seat 2 Arm Assemblies
1 Back 1 Hardware Package
Firmly tap bolts into pre-drilled
holes before tightening.
CORRECT INCORRECT
1 2 34 5
Use to measure bolts
Left Arm
Right Arm
Seat
Support
Front Crosspiece
Seat Slat
Curved Seat
Slat
(not visible)
Leg
Back Slat
Arm Support

¼" x 3½" Allen Head Bolts
¼" x 3½" Allen Head Bolts
¼" x 2½" Lag Bolt
2½" Screws
STEP #1 - Fasten the seat and the Arm Assemblies
using two ¼" x 3½" Allen Head bolts.
STEP #3 - A. Fasten arm assembly to the back using
one ¼" x 2½" Lag Bolt.
B. Fasten Back to the Seat using two
2½" Screws. Place bottom Back
Support in routed slot behind last seat
slat for placement. (See picture.)
STEP #2 - Lay the chair on the other side and repeat
Step 1.
STEP #4 - Your Adirondack chair is complete!

Assembly Directions for
Adirondack Footstool
#PAFS2400
1 2 34 5
Use to measure bolts
Firmly tap bolts into pre-drilled
holes before tightening.
CORRECT INCORRECT
HARDWARE PACKAGE
4 ¼" x 2½" Allen Head Bolts
4 ¼” Flange Nuts
1Allen Wrench
TOOLS NEEDED:
Hammer & " Wrench
Allen Wrench (Included)
PACKAGE CONTENT
1 Footstool
2 Legs
1 Hardware Package
¼" x 2½" Allen Head Bolts
¼" x 2½" Allen Head Bolts
(Opposite Side)
Slat
Leg
Support