BEST ACCESS SYSTEMS 6S User manual

BEST ACCESS SYSTEM
Indianapolis, Indiana
T56145/Rev –
1Prepare gate
See the installation specifications for 6S gate locks, numbers S09 – S12.
2Check handing
1 Unscrew the four case cover screws and lift off the case cover.
2 Check to see if you need to change the handing of the case. See the
figures below.
To change a sliding gate lock handing
1 While compressing the spring on the latch, pull the latch off of the
post. See Figure 2.
2 Turn the latch over and put the latch on the opposite post. See Figure
2.
3 Make sure that the washer fits into the recess of the cradle when the
spring is released. See Figure 2.
4 Position the retractor leg so that it contacts and retracts the latch.
See Figure 2.
To change swinging gate lock handing
1 Compress the spring on the latch and pull the latch out of the cradle.
See Figure 3.
2 Pull the latch adaptor and latch lever off of the post. See Figure 3.
3 Turn the latch lever over and reengage the latch lever to the latch
adaptor using the same slot. When switched the position should be a
mirror image of the original. See Figure 4.
4 Push the latch adaptor and lever onto the opposite post.
5 Make sure that the latch lever is on the outside of the fork leg. See
Figure 5.
6 Position the latch bevel for the correct swing of the gate.
See Figure 1.
7 Compress the latch spring and place the latch into the cradle.
Figure 1
Figure 2
LH RH
LH RH
LHRB RHRB
Spring
Latch
Post
Washer in cradle
Retractor leg
Figure 3
Figure 4
Figure 5
Spring Latch adaptor
Post
& latch lever
Latch stop
Latch
Latch lever
Latch adaptor
LH/LHRBRH/RHRB
Slot
Retractor leg
Latch lever
Installation Instructions
for 6S Gate Locks
T56145/Rev – 18XXXXX ER-7991-19 Nov 2000 1

BEST ACCESS SYSTEMS
Indianapolis, Indiana
T56145/Rev –
8 Make sure that the washer fits into the recess of the cradle when the
spring is released. See Figure 3.
9 Make sure that the latch stop fits over the edge of the latch lever. See
Figure 3.
3Install outside cylinder & ring
1 With the cam in the vertical position, tighten the cylinder retainer
screw as shown in Figure 6. If possible, use an ED211 cylinder
wrench.
2 Tighten the cylinder set screw as shown in Figure 7.
4Install case
■ Fasten the lock case into the frame of the gate.
5Install cover
For single cylinder locks
■ While rotating thumb piece, place the cover onto the case. Make
sure that the thumb piece tabs engage the slots in the case retractor
and that the cover fits snugly onto the case. See Figure 8.
For double cylinder locks
1 Install the cylinder and ring onto the cover. With the cam in the ver-
tical position, tighten both cover set screws into the cylinder
grooves. See Figure 9.
2 Place the cover onto the lock and tighten the cover set screws.
6Test lock
■ With the gate open make sure that the lock operates properly.
Figure 6
Figure 7
Cylinder retainer
screw
Cylinder
set screw
Figure 8
Figure 9
Cover
Thumb piece
Slots in
case
Case
retractor
Cover
Set screws
Cylinder groove
Cam