Kwikset Kevo User manual

Touch Sense Test
Perform the following test prior to installation to make sure
your Kevo lock’s touch sensor is working correctly.
Remove the adapter ring from the exterior assembly and
set it aside.
2
Remove the exterior assembly, interior assembly and
batteries from the package.
1
Install 4 AA batteries into the battery pack.
x4
4
Remove the mounting plate, battery cover and battery pack
from the interior assembly.
3
Connect the exterior assembly to the interior by inserting the
exterior torque blade into the turnpiece shaft.
65 Lay the interior assembly on a flat surface, with the Kwikset
label facing down.
60685 / 01

Insert the thicker cable into the square connector on the
interior assembly.
Wait about 10 seconds after initialization. Using one hand,
gently touch the exterior deadbolt rose.
8
10
12
Connect the thinner cables together.
Insert the battery pack into the interior assembly. The light
ring will spin amber during initialization.
If you see the light ring spin blue, your Kevo’s touch sensor
is working properly, and you can disconnect the parts and
install them on your door by following the Installation Guide.
IMPORTANT: Do not overtighten screws during installation.
7
9
11 If you don’t see the light ring spin blue, the touch sensor is
not functioning properly. Please call Kevo Support at
1-877-543-3358.
©2013 Kwikset Corporation