Bioness L300 Go User manual

User’s Reference Card
While seated, slightly extend your lower leg.
Tilt the top of the L300 Go FS Cuff toward you, and then slide it up your leg until the locator
rests below the kneecap. Lower the bottom of the L300 Go FS Cuff onto your leg.
Hold the L300 Go FS Cuff in place with your thumb or other hand on the EPG cradle.
Pull the strap handle around the cradle.
Figure 4 shows the L300 Go FS Cuff correctly placed on the right leg.
1
2
3
4
Putting On the L300 Go Functional Stimulation (FS) Cuff
European Authorized Representative:
Bioness Europe B.V.
Stationsweg 41
3331 LR Zwijndrecht, The Netherlands
Telephone: [phone]
Email: [email protected]
Website: www.bioness.com
Worldwide Corporate Office
Bioness Inc
25103 Rye Canyon Loop
Valencia, CA 91355
Telephone: [phone]
Email: [email protected]
Website: www.bioness.com
Operating the L300 Go System
Power Button
Stim Button
Battery Indicator Light
Charging Port
Plus Button
Status Indicator Light
Minus Button
612-00849-001 Rev. A
™
123 4
Press the on/off button to turn on the EPG.
Select either gait or training mode:
• To select gait mode, press the mode button briefly.
• To select training mode, press and hold the mode button for 10 seconds.
The EPG will acknowledge the new mode with audio and tactile feedback. Press
the mode button again to activate training mode. To exit training mode, press
and hold the mode button for 10 seconds.
If necessary, adjust the stimulation intensity level by pressing the plus or minus
button.
1
2
3

See User’s Guide
Rx Only (US only)
L300 Go™, Bioness, the Bioness Logo®and LiveOn®are trademarks of Bioness Inc. | www.bioness.com
System Error Displays
EPG Displays
(flashing) Flashes Green System is On
(flashing) Flashes Green Stimulation is Off
(flashing) Flashes Yellow Stimulation is On
(flashing) Flashes Red with Audible Alarm Active Error
Solid Red EPG Malfunction
Control Unit Displays*
Solid System is On
Stim Wave Visible System is in Gait/Training, Stimulation is
enabled but Off
Stim Wave Flashes System is in Gait/Training, Stimulation is
enabled and On
Displays 0–9 Intensity Level
Displays Gait Icon Gait Mode is Enabled
Displays Training Icon Training Mode is Enabled
Displays Audio Icon Audio is On
*Optional Component
Connect the system charger set to the EPG, then plug into a wall socket.
Charging the Batteries
(flashing)
EPG Status Indicator Bar Flashes Red along
with Battery Indicatory Light Flashing Yellow EPG Low Battery
(flashing) Flashes Yellow Low Battery
(flashing) Flashes Green Charging
(flashing) Solid Green Fully Charged
E 14
(flashing)
Faulty Electrode Contact. Ensure electrodes are snapped in, EPG fully in cradle. Clear error
alert by pressing or on EPG.
(flashing)
Low Battery Indicator on
EPG. Charge system.
EPG Malfunction. Press and hold button
for 30 seconds then power on or call Technical
Support.