Blix Prima High-step User manual

Blix Prima High-step
Assembly Guide
Notice: The following steps are only a general
guide to assist in the assembly of your Blix bike
and not a complete guide of all aspects of the
assembly. Refer to the Prima assembly video at
blixbike.com for detailed instructions. We
recommend you consult a qualified bike
mechanic to assist in the assembly, service and
maintenance of your bike.
Step 1: Remove the bike from the box and set it
on a smooth, flat surface. Remove all packaging
material from the bike and carefully cut the zip-
ties attaching the handlebars and wheel to the
frame. Make sure the below items are included
in the package. Contact Blix if any items are
missing.
!The Prima
!Pedals
!Front wheel
!Quick release for front wheel
!Fender for front wheel
!Front light
!Battery and keys
!Charger
!Tool kit
!Manual
Step 2: Install the handlebar as shown in the
assembly video at blixbike.com.
a) Make sure the bend of the front fork
points forward.
b) Position the handlebar stem onto the
bike so it points forward in alignment
with the front fork.
c) Tighten the bolt on the handlebar stem
to lock the position of the stem as
shown in the assembly video.
d) Loosen the bolt on the handlebar to
rotate the handlebar in the stem to find
your desired wrist angle. Securely
fasten the bolt to lock into position.
Step 3: Install the front wheel according to the
detailed instructions shown in the Prima High-
step assembly video at blixbike.com.
a) Remove the cap and spring from the
quick release skewer as shown in below
photo.
b) Before installing the wheel onto the bike,
push the quick release skewer through
the axle of the front wheel from the side
where the disc is attached. Reattach the
spring and cap to the quick release
skewer. Make sure the smaller end of
the spring faces inwards.
c) Install the front wheel so that It’s fully
seated on the front fork dropouts.
Tighten the quick release firmly using
your hand.
Ensure the front wheel is properly
installed, centered in the fork, and
secured as shown in the assembly
video.
www.blixbike.com!
[phone]!

Step 4: Install the front fender.
a) Attach the top part of the fender to the
attachment on the fork as shown in the
photo below.
b) Attach the fender strut to the attachment
points on the fork as shown in the photo
below.
Step 5: Install the pedal marked “L” on the left
side of the bike and pedal marked “R” on the
right side (side with chain and gears).
Tighten the pedals securely by turning the
pedals towards the front of the bike as seen in
the assembly video at blixbike.com. Install
carefully to not damage the thread.
Step 6: Insert seat post into frame and tighten
collar with wrench to the correct torque value so
that it will not slip while riding.
Step 7: Inflate the tires to the recommended
pressure 50-85 PSI, indicated on the tire
sidewall.
Recommended Torque
Values
Tighten bolts to torque specifications to prevent
the bolts from slipping.
Do not extend any components including the
stem or seat post beyond the minimum
insertion markings, which are etched into the
seat post and stem. Before using the bike,
check that the saddle post clamp is firmly
tightened. Secure all hardware properly or it
may become loose and result in serious
injuries.
Part
Torque (Nm)
Seat post clamp
7
Saddle
18-20
Pedals
35
Crank bolts
40
Handlebar
18-20
Stem
18-20
Rear wheel
40-45
www.blixbike.com!
[phone]!