BluDot Shale 2 Door 2 Drawer Wall-Mounted Cabinet Quick start guide

BEAUTILITY!
Pick the height that is right for your space. Door units feature adjustable
shelves and wire management holes.
Shale Wall-Mounted Cabinet
DESIGNED IN 2013
ASSEMBLY NOTES | REV 00
NEED A HAND?
Contact us at [email protected] or
844.425.8368 for assistance.

1 | 8 4 4 . 4 2 5 . 8 3 6 8 SHALE WALL-MOUNTED CABINET
Wall Bar
1QTY
Parts & Hardware

[e-mail] | 2ASSEMBLY NOTES
*****
Desired Height
1-1/4 in. lower
* It is recommended that you consult with a professional to determine
the method and hardware required for installation.
Step 01
INSTALL THE BAR.
Attach Wall Bar using outermost holes first, then distribute the other
screws based on the wall studs.* Position the top of the wall bar
1-1/4” lower than your desired height of the Shale unit.
Step 02
MAKE THINGS EASIER.
Depress the release levers
located on the under side
of the top drawer while
opening to clear it from
the cabinet.

BLU DOT DESIGN & MANUFACTURING, INC. DESIGNED IN MINNEAPOLIS, MN
1
2
Additional Information
CLEAN
Clean with a slightly damp, soft cloth. To remove dirt and fingerprints, use a quality cleaner formulate
for wood furniture. Wipe completely dry with a soft cloth in the direction of the wood grain.
Step 03
HANGING / ADJUSTING.
To make sure each of the three cabinet
hangers within the console latch
over the wall bar, extend the cabinet
hanger brackets by turning the front
adjustment screw counter clockwise.
To effectively change the position
of the console, adjustment screws
must be a changed on all three of the
cabinet hangers. Use a level to check
for squareness. If sagging occurs,
adjust center cabinet hanger
1. Front adjustment screw
changes the pitch of
the console. Rotate the
screw clockwise to move
the console closer to
the wall.
2. Bottom adjustment
screw changes the
height of the console.
Rotate the screw
clockwise to move
the console up.