BluDot Dang Long and Low Quick start guide

Dang Long and Low
DESIGNED IN 2016
ASSEMBLY NOTES | REV 02
NEED A HAND?
Contact us at [email protected] or
844.425.8368 for assistance.
ALMOST SEEMS A SHAME TO MUCK IT UP WITH A TV.
Perforated steel door fronts allow use of remotes without
spoiling the view. Brass details and powder-coated steel base.

1 | 844.425.8368 DANG LONG AND LOW
Case
1QTY
8041
Anti-tip Bracket
Pt. 8041
2QTY
Pt. 1218
2QTY
Pt. 1217
2QTY
8042
Anti-tip Strap
Pt. 8052
2QTY
Pt. 8042
1QTY
door
2QTY
Parts & Hardware

[e-mail] | 2ASSEMBLY NOTES
Side view. Side view.
Step 01
INSTALL DOORS.
Install the sliding doors as shown.

3 | 844.425.8368 DANG LONG AND LOW
1” lower than
case top
Side Panel
PT. 8052 x 2
Step 02
INSTALL WALL ANCHORS.
Wall anchors and fasteners are included for
installation into drywall. Please consult your
local hardware professional to determine the
hardware best suited for your wall type.
If the mounting locations are not positioned
on a stud, drill 5/16” holes in the marked
locations. Press wall anchors into drilled holes.
If the mounting locations are positioned on a
stud, this step of installing wall anchors may
be skipped. Instead, drill 7/64” pilot holes in
the marked positions.
Wall

[e-mail] | 4ASSEMBLY NOTES
8041
Anti-tip Bracket
Pt. 8041 x 1 Pt. 1218 x 2
1” lower than
case top
Install anti-tip bracket to wall stud 1-inch
below case top panel height.
Step 03
ATTACH ANTI-TIP BRACKET TO
THE WALL.
Side Panel
Wall

5 | 844.425.8368 DANG LONG AND LOW
Pt. 1217 x 2
8041
Anti-tip Bracket
Pt. 8041 x 1
Back
Panel
Top
Rear of Case
Bracket must be installed to top panel
of case. In order to prevent damage, it is
recommended that 3/32” pilot holes be
drilled prior to installation.
Step 04
INSTALL ANTI-TIP BRACKET
TO CASE.

[e-mail] | 6ASSEMBLY NOTES
8042
Anti-tip Strap
Pt. 8042 X 1
Step 05
SECURE THE CASE.
Install and tighten the strap
prior to using the product.

BLU DOT DESIGN & MANUFACTURING, INC. DESIGNED IN MINNEAPOLIS, MN
Additional Information
CLEAN
Clean with a slightly damp, soft cloth. To remove dirt
and fingerprints, use a quality cleaner formulate for
wood furniture. Wipe completely dry with a soft cloth
in the direction of the wood grain.