BluDot DODU BED-TWIN Quick start guide

BLU DOT DESIGN AND MANUFACTURING, INC. copyright 2007.
www.bludot.com / t. 612.782.1844 / f. 612.782.1845
HARDWARE INVENTORY
1 hex key16 screws
DODU BED- TWIN PAGE 1
Assembly Notes
Assemble on carpet or protective mat.
1
2
REV 1 2007.01.05
A
B
C
1
B
C
Orient each siderail as shown in diagram 2. Note that the end closest to the headboard should have a larger hole pattern on the side.
Push the hooks on the side rails into the slots in the headboard and footboard. Firmly press down on the siderails to make sure the hooks
engage.
Attach the rails together by screwing in the corner brackets. First attach the smaller brackets to the headboard and side rails. Place the
bracket in place, add a washer, and then a screw. Use the hex key to tighten the screws. Repeat to attach the larger brackets to the
footboard and side rails.
2
A
Larger hole pattern
16 washers
X4

BLU DOT DESIGN AND MANUFACTURING, INC. copyright 2007.
www.bludot.com / t. 612.782.1844 / f. 612.782.1845
DODU BED- TWIN PAGE 2
Assembly Notes
3
4
REV 1 2007.01.05
FELT UPHOLSTERY CARE
CLEAN: Vacuum your upholstery regularly. For
occasional cleaning remove the slipcover and have
it cleaned by a professional dry cleaner. Always
clean the entire cover together. Colors may undergo
subtle changes during the dry cleaning process.
Never machine or hand wash the slipcover. After a
professional cleaning the slip cover may fit snugly.
Stretch it gently over the bed frame to fit. If the
slipcover is heavily wrinkled, use a steamer to
eliminate creases.
SPILL: Act quickly with spills. Absorb the spill with
a clean white cloth or paper towel. Never rub the
surface. If the spill has already set, use a very mild,
dye-free wool detergent mixed with lukewarm water
and blot with a clean cloth or sponge. If necessary,
have the entire slipcover professionally cleaned.
AVOID: Keep your felt upholstery furniture out of
direct sunlight and away from heat sources as
excessive exposure to sunlight will fade the color of
the upholstery. Avoid placing heavy or sharp objects
on the furniture surface for long periods of time as
this can cause permanent indentations in the
fabric. For snags on the fabric, tuck the loose
threads into the fabric or carefully push through to
the reverse side. Never pull out or cut off loose
threads.
Lay the slats into the frame with the curve of the slats facing up.
Now you can install the slip cover. Slip the large portion over the headboard then slip the rest over the side rails and footboard. Finally,
secure the velcro on the slip cover to the velcro on the bed frame keeping the edges smooth and in line with the edges of the frame.
3