BM PRO ProSmart User manual

ProSmart Install Guide
TEAM
BMPRO
.COM
2. description of parts
1. overview
3. mounting
5. pairing4.app
ProSmart is a sensor monitor with an app to easily track multiple sensors and parameters on your adventure, whether you
travel by an RV, a boat, a 4WD or an overland vehicle, giving you a wealth of information for comfort and safe travels. Monitor
water levels in your fresh or grey water tanks, gas levels in your BBQ / propane bottles, tyre pressure (TPMS), temperatures
in the fridge, freezer or inside your vehicle, as well as your 12V battery charge, all from an easy-to-use app on your
smartphone.
1. Dip Switch
2. Display Port
3. CAN Bus Port
4. Water Tank Sensor Connections
5. Product Page QR Code
6. Serial Number
7. Antenna
8. Pairing LED
9. Pairing Button
10. Wired Temperature Sensor Connections
11. 12V Input Connection
To mount the SmartLink:
1. Create openings for cable
connections if necessary.
2. Mount the SmartLink to the wall
with screws.
3. Make all connections.
For caravan/RV installations, mount it at a high point to avoid
the metal chassis and tow bars, which can cause signal
interference.
To ensure optimal antenna performance, avoid placing the
SmartLink near conductive or metal objects.
Use the QR code to
download the
ProSmart app.
When opening the ProSmart app for the first time, you will
need to pair the SmartLink.
From the Welcome screen:
1. Press Start.
2. Press Continue.
3. If required, allow access to your device’s location.
4. Once the Pair your SmartLink screen displays, press the
pairing button on the SmartLink.
57.0 (2.244”)
MAXIMUM 4 DEVICES
CONNECTED AT ONCE
UP TO 40 SMARTCONNECT SENSORS
CONNECTED AT ONCE
UP TO 4 WATER TANKS
CONNECTED AT ONCE
SmartPressure
TYRE PRES SURE SENSOR
SmartSense
LPG TANK SENSOR
SmartTank
TEMPERATURE SENSOR
SmartSecure
OPEN/CLOSE SENSOR
WIRED TEMPERATURE SENSOR
HOUSE BATTERY
DOC PART 38646
REV 1.0

7. analog water dippers
6. led status indicator
TEAM
BMPRO
.COM
To connect an analogue dipper to your SmartLink:
1. At the top of the SmartLink, move pin 2 to the off
position on the red dip switch.
2. On the bung wiring loom, connect the red wire to pin 1
of the SmartLink’s water tank sensor connection.
3. Connect the white earth wire at the bottom of the tank
to pin 5 of the SmartLink’s water tank sensor
connection.
4. Follow the analogue dipper’s instructions to connect it
to the water tank.
SMARTPRESSURE SMARTSENSE SMARTTEMP SMARTSECURE
Red (Pin1)
White(Pin5)
STATE LED STATUS
Flashing white and yellow
Flashing Blue
Flashing Amber-Green
Single Red flash
Initialisation
Pairing
The maximum of four mobile
devices has been reached
All mobile devices have been
forgotten
DOC PART 38646
REV 1.0