Body Clock Profile TENS User manual

TM
Profile TENS
Instructions for use
Pr file TENS Inst UK 2009.qx7:Lay ut 1 10/6/09 11:11 Page 1

TechnicalData .......................1
Fun tions ...........................2
Professional functions . . . . . . . . . . . . . . . .3
Instru tions for use ..................4
Controls ............................7
Key: ...............................8
Precautions & Contraindications: . . . . . . .9
ContentsBefore you use your Body
Clo k Profile TENS, it is
important that you read
this manual arefully.
It ontains all the
information you need to
ensure you are using the
unit safely and orre tly.
Pr file TENS Inst UK 2009.qx7:Lay ut 1 10/6/09 11:11 Page 2

Equipment Type:
Dual channel digital TENS
Output Voltage:
0 – 50v peak to peak adjustable in levels
0 – 20 (through a 500 Ohm load)
Output Intensity:
0 -100 mA peak to peak adjustable in level
0 - 20 (measured across a 500 Ohm load)
Level 0 is Ov and has no output
Frequen y:
50 selectable frequencies - adjustable up
or down 1-200 z
i.e.1,2,3,4,5,6,7,8,9,10,11,12,13,14,15,16,17,
18,19,2022,24,26,28,30,35,40,45,50,55,60
,65,70,75,80,85,90,95100,105,110,120,130,
140,150,160,170,180,190,200 z
Pulse Width:
10 selectable pulse width settings
adjustable up or down 25,50,75,
100, 125,150,175,200,225, and
250 microseconds
Output waveform:
Symmetrical bi-phasic rectangular
Output Modes:
5 selectable modes
(a): Constant
(b): Burst 1 – Fixed 1 burst per 2 seconds.
Each burst consists of 80 pulses. Pulse
width is adjustable.
( ): Fixed 2 bursts per second. Each burst
consists of 7 pulses. Pulse width
is adjustable.
(d): Width Modulation – Pulse width
modulates between 25-250µs, ramp
up for 8 seconds and ramp down for 8
seconds. Frequency is adjustable.
(e): Rate Modulation - Frequency
modulates decreasing from 100 z to
20 z in a period of 8 seconds. The
frequency then increases from 20 z to
100 z in the next 8 seconds. This
pattern is then repeated. Pulse width
is adjustable.
1
Profile TENS Te hni al Data
Pr file TENS Inst UK 2009.qx7:Lay ut 1 10/6/09 11:11 Page 1

Timer:
7 selectable settings
(a) Continuous (b) 10 minutes
(c) 15 minutes (d) 20 minutes
(e) 30 minutes (f) 45 minutes
(g) 60 minutes
Output Ja ks:
CE touchproof
Batteries:
2 x 1.5 v AA batteries (type LR6)
Fun tions
Memory:
Saves last mode attempt in memory
i.e. the next time the unit is used it will
start again at the same setting as before.
This memory is erased when batteries
are changed.
Mode Change:
When the mode is changed, the intensity
level will drop back to zero. It will then
gradually increase to the level set by
the user.
Display:
In both modulation modes, output
changes are visible on the display.
Timer:
Timer counts down in minutes when timer
is on.
Automati shutdown:
If intensity levels are ‘O’ on both channels
and if the unit has not been in use for five
minutes it will shut down automatically.
Low battery indi ator:
A flashing symbol indicates low battery.
Load dete tor:
If an electrode should accidentally detach
itself from the body or the leadwire,
the intensity will drop to zero.
2
Pr file TENS Inst UK 2009.qx7:Lay ut 1 10/6/09 11:11 Page 2

Professional Fun tions
Permanent time used memory:
Memorises up to 99 hours used time.
Display appears in hours and minutes.
Number of times used:
Provided the unit is in use for five minutes
with the intensity activated, the unit will
memorise the number of times the unit
is used.
Lo k/unlo k parameter fa ility:
Option to lock and unlock device settings.
When batteries are removed, parameters
are retained provided the locking facility
is activated
Specifications are nominal and subject to
variation from listed values due to normal
production tolerances of ± 10 %.
Classifi ation
This unit is fully compliant with EEC
Directive 93/42/EEC, classified as internally
powered Equipment Type BF. It is
intended for continuous operation.
Equipment providing a
particular degree of protection
against electric shock partic-
ularly regarding allowable
leakage currents having an F
type (floating) applied part.
Warning - refer to these
instructions and “Easy Guide to
TENS Pain Relief”
Denotes a product which
must be disposed of safely.
3
Pr file TENS Inst UK 2009.qx7:Lay ut 1 10/6/09 11:11 Page 3

Output waveform Instru tions for use
The Profile TENS is a dual channel TENS,
supplied with leadwires, electrodes,
battery and carrying pouch.
1. Slide battery cover off by gently
pressing on the triangular ribbed area
with your thumb and move downwards.
Insert batteries, ensuring the positive
and negative terminals are correct as
marked inside the battery
compartment. Ensure that the ribbon is
left underneath the batteries as this will
assist you when the batteries need to
be removed. Replace battery cover.
2. Insert the leadwire pins
into the electrodes.
3. If using carbon rubber
electrodes spread on a small amount of
gel and affix with surgical tape (not
supplied).
4
Pr file TENS Inst UK 2009.qx7:Lay ut 1 10/6/09 11:11 Page 4

4. If using self-adhesive electrodes,read
instructions provided with the
electrodes and ensure your skin is free
from oil, talc, etc.
5. Position electrodes in accordance with
the guidelines illustrated in “An easy
guide to TENS Pain Relief” or preferably
with your medical adviser. NB It is a
safety feature of the Profile TENS that
the intensity controls will only work if
the leadwires are connected with
electrodes attached to the skin.
6. With the unit swit hed off, insert the
leadwires into the sockets (see diagram
on page 7). You are now ready to
commence stimulation.
7. Turn on the unit by means of the
ON/OFF button.
8. Set the pulse rate (frequency) control to
the 2 z
9. Pulse Width adjustment provides extra
versatility. Increasing or decreasing the
setting heightens or lessens the
sensation at the site of the electrodes.
Set initially to 100, then adjust as
desired.
10. Slowly turn up the intensity using the
intensity controls (see diagram on
page 7).
11. By setting the pulse rate control to
the upper end of the pulse rate range
(80 z or above) you feel a tingling
sensation. This is the Gate Control
Theory. Please refer to the accompanying
Book “An Easy Guide to TENS Pain
Relief” page 3, for a full explanation.
12. Effective pain relief may also be
achieved at the lower end of the pulse
rate range - approx 2 z, this will feel
like a heart beat. This is the
acupuncture-like TENS or endorphin
release theory. Please see page 3
in“An Easy guide to TENS Pain Relief.”
5
Pr file TENS Inst UK 2009.qx7:Lay ut 1 10/6/09 11:11 Page 5

13. With the mode button then select the
mode you wish to use. There are five
modes to choose from.- Constant: The
pulses are steady and continuous;
Burst 1 The pulses are off and on in
regular cycles resembling massage;
Burst 11 The pulses are off and on in
regular cycles in a tapping rhythm.
Width modulation; Pulse width
modulates to create a gentle ebbing
and flowing effect. Frequen y
modulation; Pulse rate quickens and
then slows down creating a pleasant
tingling sensation.
14. Varying the modes helps avoid or
delay your body becoming used to
any particular setting. Your medical
adviser will be pleased to assist you
with electrode positions and settings.
Continue stimulating for as long as
necessary but preferably for no
less than 30 minutes unless you
experience discomfort.
15. Some people achieve pain relief after a
short period, while others may require
to use their TENS for longer.
16. If you stimulate for a number of hours
check there is sufficient gel on carbon
rubber electrodes. If using self-
adhesive electrodes check they have
not dried out. If this happens, dampen
slightly. If electrodes dry out this can
cause minor skin irritation.
17. The timer allows you to pre-set your
Profile TENS to switch off automatically
and the LCD display will keep you
informed about the amount of time
your treatment still has to run.
18. When you have finished stimulating,
turn the machine off by pressing the
On/Off button (see diagram on page 7).
19. Ensure that the unit is switched off before
removing the leads. Do not pull the
wires. Remove leads by holding the jack
plug between the forefinger and thumb.
6
Pr file TENS Inst UK 2009.qx7:Lay ut 1 10/6/09 11:11 Page 6

7
Profile TENS Controls

Intensity control
for channel 2

On/off control

Jackplug/Leadwire
sockets

Frequency control

Protective
casing

Pulse width control

Mode

Timer
쐅
LCD display

Intensity control
for channel 1
Pr file TENS Inst UK 2009.qx7:Lay ut 1 10/6/09 11:11 Page 7

8
Profile TENS Key
and Two way buttons to increase
and decrease intensity for channels 1 and
2. Pressing the UP arrow increases
intensity. Pressing the DOWN arrow
decreases intensity. The selected level of
intensity is indicated on the LCD screen by
means of black bars on the left of the
screen for Channel 1 and on the right for
Channel 2.
This button switches the machine on
and off. Press once to turn the unit on.
There will be no feeling from either
channel at this time because the intensity
always starts at zero. Press this button
again to switch the machine off.
Jack plug sockets.
Frequency (pulse rate) control. This
two way button enables you to select the
frequency you require between 1 - 200 z
Protective cover closes over screen
with belt clip on reverse for ease of use.
Pulse width control. This two way
button enables you to adjust the pulse
width upwards or downwards as desired
between 25 - 250 microseconds.
Mode selector button.
Timer. This unit has 7 selectable settings
(i) continuous When the unit is first used (or
after removal of batteries unless you have
activated the locking facility) it will be
automatically in constant time. This means
that the unit will work continuously until it is
switched off by the user. In this setting
there is no time display on the screen. (ii) If
a specific time is selected, time will count
down on the screen as the unit is used. You
simply press the timer button to select the
time in minutes which you require. The unit
will shut down automatically after the timer
has completed counting.
쐅LCD display.
Pr file TENS Inst UK 2009.qx7:Lay ut 1 10/6/09 11:11 Page 8

9
1. Do NOT use the Profile TENS if you have a
cardiac pacemaker.
2. Check with your medical adviser before
using if you suffer from a heart condition,
epilepsy, undiagnosed pain, have any
metal implants, or any doubts whatsoever.
3. TENS must NOT be used before the 37th
week of pregnancy.
4. Never use TENS to mask undiagnosed
pain since this could require
urgent treatment.
5. If you are pregnant, do NOT place the
electrodes over your abdomen.
6. Do NOT use this unit without first reading
these instructions.
7. Do NOT immerse the Profile TENS in any liquid.
8. Do NOT place it close to any source of
excessive heat or operate it in the
presence of flammable gas.
9. Do NOT drop this unit onto a hard surface.
10. Do NOT attempt to dismantle the Profile TENS.
11. Only use specified batteries and electrodes.
12. If damaged, do not use. Return to supplier.
13. Remove the batteries when not in use.
14. Do NOT use while driving or operating
potentially dangerous machinery or while
using a microwave.
15. Keep out of the reach of children.
16. Do NOT place electrodes on or near the
eyes, in the mouth, over the front or sides
of the neck, across the head, heart, or an
area of broken, inflamed, infected or numb
skin. Electrodes should generally only be
applied to skin with normal sensation
unless under medical supervision.
17. Do NOT use in the presence of
tuberculosis, malignant tumours, very high
or very low blood pressure, epilepsy, high
fever or acute inflammatory disease unless
under medical supervision.
Guarantee
Your Profile TENS machine is guaranteed
for a period of 5 years against
manufacturer’s defects.*
*The guarantee does not include leads, electrodes or battery
Pre autions and ontraindi ations
Pr file TENS Inst UK 2009.qx7:Lay ut 1 10/6/09 11:11 Page 9

Body Clo k Health Care Ltd
108 George Lane
South Woodford
London
E18 1AD
Tel (+44) (0)20 8532 9595
Fax (+44) (0)20 8532 9551
www.bodyclock.co.uk
e-mail customercar[email protected]
0120
June 2009 (3)
Pr file TENS Inst UK 2009.qx7:Lay ut 1 10/6/09 11:11 Page 10