Bodyworx LCF128 User manual

HEAVY DUTY
POWER RACK
Model No:
LCF128
Retain this owner’s manual for future reference
Read and follow all instructions in this owner’s manual
Version A

Contents
Assembly Instructions
Contents
Before You Begin
Assembly Steps
1
2
3-4
Parts & Hardware List 5
Page 1

Before Your Begin
Assembly Instructions
Page 2
This exercise equipment is built for optimum safety. Be sure to read the entire
manual before you assemble or operate your equipment. Please note the following
safety precautions:
1. Keep children and pets away from the equipment at all times. Do not leave
children unattended in the same room with the equipment.
2. Only one person at a time should use the equipment.
3. If the user experiences dizziness, nausea, chest pain, or any other abnormal
symptoms STOP the workout at once.
CONSULT A PHYSICIAN IMMEDIATELY.
4. Position the equipment on a clear, level surface. DO NOT use the bench
near water or outdoors.
5. Keep hands away from all moving parts.
6. Always wear appropriate workout clothing when exercising. DO NOT
wear robes or other clothing that could become caught in the equipment.
7. Use the equipment only for its intended use as described in this manual.
DO NOT use attachments not recommended by the manufacturer.
8. Before using the equipment, always do stretching exercises to properly warm up.
9. Never operate the equipment if the equipment is not functioning properly.
Tools Required
Tools Required : Allen Wrentch Set / Socket Wrentch Set
Adjustable Wrentch / Crescent Wrench
Rubber Mallet / Tape Measure
ASSEMBLY REQUIRES AT LEAST THREE PERSONS
Note:
1.Only hand tighten all nuts and bolts until whole equipment
assembled.
2.Descriptions of pieces as LEFT and RIGHT are from
the point of view of standing behind the equipment facing
towards the front.

Assembly Instructions
Page 3
STEP 1
1
W12
36x
N12
16x 2
4
5
3
H12x16H12x16
x12
H12x18H12x18
x4
H12x18H12x18
x4

Assembly Instructions
Page 4
STEP 2
6
9
8
10
7
7
H12-18H12-18
x4
H12-3H12-3
x4
W12
x8
10
10
7
Note:Justify and align all parts accurately and tighten all bolts fully.
W8
4x
N8
4x

Assembly Instructions
Page 5
Parts & Hardware List
Part# Description Qty Remark
1 Right Upright 1
2 Left Upright 1
3 Bar Holder 4 Pre-assembled
4 Bottom Cross Frame 1
5 Top Rear Cross Frame 1
6 Top Front Cross Frame 1
7 Safety Bar Holder 2
8 Right Handle 1
9 Left Handle 1
10 Safety Bar Holder Cover 2 Pre-assembled
Pre-assembled
Pre-assembled
H12-3 M12x25 mm Hex Head Bolt 4
H112-16 M12x90 mm Hex Head Bolt 12
H112-18 M12x100 mm Hex Head Bolt 12
W12 M12 Washer 44
N12 M12 Nut 16
W8 M8 Washer 4
N8 M8 Nut 4

BODYWORX
BODYWORX
Model No: LCF128
To register your warranty, please go to
www.gpisports.com.au