Bosch FERION 1000 O User manual

Smoke Alarm
FERION 1000 O
en

Table of contents
1Graphics 4
2Introduction 6
3Mounting 7
4Maintenance 9
5Technical data 10
6Customer Service 11
Smoke Alarm Table of Contents | en 3
Bosch Sicherheitssysteme GmbH 08.15 | 3.1 | F.01U.309.848

1 Graphics
(1) minimum
additional
unsuitable
>20°
(2.A) (2.B) (2.C) (2.D)
>20°
>1m 1m
>20°
0.5-1m
0.5-1m
0.5m
0-20°
4en | Graphics Smoke Alarm
08.15 | 3.1 | F.01U.309.848 Bosch Sicherheitssysteme GmbH

A
1
2
60 mm
(5)
B
1
1
1
1
A
(3) 1 x 3 mm
2 x 3 mm
+
+
1
(4)
< 2 s
(6)
(7)
B
Smoke Alarm Graphics | en 5
Bosch Sicherheitssysteme GmbH 08.15 | 3.1 | F.01U.309.848

2 Introduction
The FERION 1000 O smoke alarm device with built‑in siren (4.1),
big button for operation (4.2) and replaceable batteries (6.1) is
solely designed for residential applications. The device reliably
warns you of the emergence of a fire in your house or flat. If the
smoke emissions exceed a certain limit, an alarm is raised. More
information, CE declaration, and declaration of performance is
available on www.boschsecurity.com/ferion/.
The safety notes and instructions contained in this manual must
be observed in order to ensure proper function. The device must
not be modified in any way. If you have any questions about the
method of operation, safety or connection of the device, consult
the place of purchase.
!
Caution!
Only use original parts. Only use installation materials
as recommended in this manual. Do not paint over the
device! Do not cover it with wallpaper! Replacement
after 10 years recommended.
Notice!
Do not use if there are signs of damage, or in case of
malfunction. Return defective devices to the place of
purchase.
6en | Graphics Smoke Alarm
08.15 | 3.1 | F.01U.309.848 Bosch Sicherheitssysteme GmbH

Used batteries or old devices are not to be disposed
of with the household waste. Dispose of them
according to the guidelines for electric and
electronic waste at the local collection points.
Parts included
1 smoke alarm device: base (3.A) and detector head (3.B), 2
batteries, fastening material: 1 screw, 1 plug
3 Mounting
Notice!
The device is designed for mounting according to DIN
14676 on flat or slanted ceiling. Wall mounting is not
allowed.
Perform the following steps. Find exact information about the
single steps on the following pages in this manual. See also the
graphics at the beginning of this manual.
1. Determination of mounting locations. (1) Observe the
information regarding Unsuitable locations for mounting, page
8, and regarding Audibility, page 8. Each device is to be
mounted horizontally on the ceiling in centered position with
a minimum distance of 0.5m to walls and objects. On slanted
ceilings >20° it is to be mounted 0.5m to 1m from the top of
the ceiling. (2.A), (2.B), (2.C), (2.D)
2. For each device: Inserting batteries, page 8. Observe the
polarity. (6.1)
Smoke Alarm Graphics | en 7
Bosch Sicherheitssysteme GmbH 08.15 | 3.1 | F.01U.309.848

3. For each device: Mounting the base. (5) Observe the marks
(5.1) for alignment with BOSCH label/siren.
4. Functional check, page 9, for each device after setting it up
into operation. (6) (7)
Unsuitable locations for mounting
– Kitchen/bathroom (steam)
– Rooms with open fireplaces (fumes)
– In the immediate vicinity of halogen lamps, transformers,
fluorescent or energy-saving lamps
– Garages (exhaust fumes)
– Dusty and dirty rooms
– In the vicinity of windows, ventilators (air movement)
– In the vicinity of areas where people smoke
Audibility
You must hear an alarm at any place in your building or flat. The
alarm really has to wake you up. If necessary adapt the number of
the devices for achieving audibility in your whole building or flat.
Inserting batteries
Notice!
The detector head will only latch into the base when
the batteries are inserted.
Insert new FUJITSU LR6 G or GASSNER LR6 batteries in the
battery compartments, observing the polarity shown. (6.1)
8en | Graphics Smoke Alarm
08.15 | 3.1 | F.01U.309.848 Bosch Sicherheitssysteme GmbH

Mounting the base
Mount the base with one central screw and plug. (5.A), or
optionally use two screws and plugs. (5.B) To set the device into
operation you screw the detector head to its base by twisting it
clockwise until it latches. (6)
4 Maintenance
Functional check
A visual inspection and a functional check must be performed for
each device monthly. After the functional check the device is
muted for 10 min, even when an alarm will be triggered. After
10 min the device will switch to normal mode again.
– The device is in normal mode (no signal). To perform the
functional check press and release the button (< 2 s). (6) ->
Siren sounds 3 times ≥85 dB(A).
If the functional check fails the device is defective and must be
replaced.
Siren off (alarm signal)
If you press and release the button (< 2 s) of a device that has
triggered an alarm, then the device stops sounding. After 10 min
the device will switch to normal mode again.
Battery replacement
If the siren sounds short every 43 s (weak battery) you have to
replace the batteries.
1. Remove the head and insert new FUJITSU LR6 G or GASSNER
LR6 batteries in the battery compartments, observing the
polarity shown. (6.1)
Smoke Alarm Graphics | en 9
Bosch Sicherheitssysteme GmbH 08.15 | 3.1 | F.01U.309.848

2. Screw the head to its base again and perform the functional
check.
Polluted smoke chamber
If the siren sounds short 3 times every 43 s (polluted smoke
chamber), then you have to replace the device.
5 Technical data
Sound pressure level at a distance of
3m in dB(A)
≥85
Power supply (2 x 1.5V, replaceable
batteries)
GASSNER LR6
FUJITSU LR6 G
Dimensions (diameter x height, mm) 119 x 50
Weight, incl. batteries (g) 168
Protection category (EN60529) IP20
Operating temperature (°C)* 0 … +45
Storage temperature (°C)* -10 … +55
Relative humidity (%, noncondensing) 93
Guarantee (without batteries, y)** 5
Typical battery lifetime (y) *** 5
* high temperature (> +30 °C) reduce the battery lifetime
** during standard usage and operation as stated in the user
guide
10 en | Graphics Smoke Alarm
08.15 | 3.1 | F.01U.309.848 Bosch Sicherheitssysteme GmbH

*** based on typical storage temperature (-5 … +30 °C) and
typical operating temperature (+5 … +30 °C) and monthly
functional tests
Certification CE ,
Harmonized standards EN 14604:2009-02
Signals
Mode Audible
Normal -
Functional test OK 3 x ≥85 db(A) / 4 s
Alarm 3 x ≥85 db(A) / 4 s
Weak battery 1 x short / 43 s
Polluted smoke chamber 3 x short / 43 s
6 Customer Service
Replacement of the product is only possible with proof of
purchase during guarantee.
Smoke Alarm Graphics | en 11
Bosch Sicherheitssysteme GmbH 08.15 | 3.1 | F.01U.309.848

Great Britain
Robert Bosch Ltd. (B.S.C.)
P.O. Box 98
Broadwater Park
North Orbital Road
Denham
Uxbridge
UB 9 5HJ
Tel. Service:
[phone]
E-Mail:
[email protected]
m
Ireland
Origo Ltd.
Unit 23 Magna Drive
Magna Business Park
City West
Dublin 24
Tel. Service:
[phone]
Fax: [phone]
12 en | Graphics Smoke Alarm
08.15 | 3.1 | F.01U.309.848 Bosch Sicherheitssysteme GmbH

Bosch Sicherheitssysteme GmbH
Robert-Bosch-Ring 5
85630 Grasbrunn
Germany
www.boschsecurity.com
© Bosch Sicherheitssysteme GmbH, 2015