BOSS ILLUMINATION ARIES User manual

www.bia.lighting | [email protected]page 1 / 2
PRODUCT MANUAL
COPYRIGHT BIA ©2020 V07.20
Disclaimer: Please read these warranty
and installation instructions carefully
before installing the product.
BIA products are manufactured
and certied in accordance with all
mandatory Australian Standards.
All products must be installed by a
licensed electrician, in accordance
with relevant Australian Standards.
Technical data and information subject
to changes, visit our website for the
most updated version.
WARRANTY STATEMENT This product is covered by a 5 year replacement warranty.
BIA guarantees this product to be free of defects from the date of purchase for the stated period above. If product fails within the warranty period, BIA will x
or replace the product. This excludes any costs associated with the removal or installation of product. This warranty is subject to the terms and conditions stated
on www.bia.lighting. Failure to comply with installation guidelines will automatically void the warranty. Please retain purchase receipt. For more information on
warranty please visit www.bia.lighting/warranty
BIA reserves the right to change specications and other information, modify products and discontinue items without prior notication.
PRODUCT VARIANTS
POWER : 200W
500W
800W
1000W
CCT : 3000K
4000K
5000K
5700K
Beam Angle : 30° x 30°
45° x 45°
60° x 60°
75° x 75°
85° x 45°
85° x 90°
85° x 135°
60° x 135°
PRODUCT SPECIFICATIONS
Input Voltage : 100-305VAC 50/60Hz
Ambient Temperature : -10 to 45°C
Dimming : No
Weight : 9kg - 38kg
ARIES
FLOOD LIGHT
Must be installed by
a licensed electrician.
Must be installed
in accordance with
relevant Australian
Standards.
ADDITIONAL INFORMATION
1. This luminaire is not dimmable.
2. Luminaire installation angle is adjustable. Refer instructions
overleaf.
3. Installation must be carried out with care to ensure the surface of
the luminaire is not scratched or damaged. Damaged surfaces will
result in material corrosion when exposed under harsh weather
conditions.
4. Please ensure luminaire cover is sealed.
5. If cleaning maintenance is required, use a clean microbre cloth,
slightly dampened with a mild dilution of detergent that is PH
neutral, alcohol free and non-abrasive.
PARTS INCLUDED
LED
Luminaire
IP66

www.bia.lighting | [email protected]page 2 / 2
PRODUCT MANUAL
COPYRIGHT BIA ©2020 V07.20
8
0
7
0
6
0
5
0
4
0
3
0
2
0
1
0
0
1
0
2
0
3
0
4
0
5
0
6
0
7
0
8
0
INSTALLATION INSTRUCTIONS
1. Before commencing installation, ensure the main power is
switched off.
2.
A Mount the bracket onto the installation
surface by securing the middle hole
with one set of M20 screws.
or
B Mount the bracket onto the installation
surface by securing the bracket with
four sets of M12 screws.
3. Connect the cables together. Ensure appropriate waterproong
needs if required.
4. Loosen the nut screws on the sides to adjust the angle of the
luminaire, tighten to secure the angle.
5. Turn on main power.
WARNING! Silicone must be applied to all screws and wire entry
points to enforce IP rating.
DIAMENSION DIAGRAM
833mm593mm507mm
91mm
244mm
743mm
384mm
478mm
117mm
170mm
621mm
621mm
367mm
764mm
500W
21kg
200W
9kg
800W
29kg
1000W
38kg
4
3
1. screw nut
2. spring shim
3. at washer
4. screw
2