BOSS ILLUMINATION Fort User manual

www.bia.lighting | [email protected]page 1 / 2
PRODUCT MANUAL
COPYRIGHT BIA ©2019 V06.19
Disclaimer: Please read these warranty
and installation instructions carefully
before installing the product.
BIA products are manufactured
and certied in accordance with all
mandatory Australian Standards.
All products must be installed by a
licensed electrician, in accordance
with relevant Australian Standards.
Technical data and information subject
to changes, visit our website for the
most updated version.
WARRANTY STATEMENT This product is covered by a 2 year replacement warranty.
BIA guarantees this product to be free of defects from the date of purchase for the stated period above. If product fails within the warranty period, BIA will x
or replace the product. This excludes any costs associated with the removal or installation of product. This warranty is subject to the terms and conditions stated
on www.bia.lighting. Failure to comply with installation guidelines will automatically void the warranty. Please retain purchase receipt. For more information on
warranty please visit www.bia.lighting/warranty
BIA reserves the right to change specications and other information, modify products and discontinue items without prior notication.
PRODUCT VARIANTS
POWER : 10W
20W
30W
50W
CCT : 3000K
6000K
PRODUCT SPECIFICATIONS
Input Voltage : 220-240VAC
Ambient Temperature : -10 to 45°C
Dimming : No
FORT
FLOOD LIGHT
Must be installed by
a licensed electrician.
Must be installed
in accordance with
relevant Australian
Standards.
ADDITIONAL INFORMATION
1. Luminaire covers in different designs and colours available.
2. This product is suitable for outdoor use.
3. If cleaning maintenance is required, use a clean microfibre cloth,
slightly dampened with a mild dilution of detergent that is PH
neutral, alcohol free and non-abrasive.
PARTS INCLUDED
LED
Luminaire
IP65
Mounting
Bracket &
Accessories

www.bia.lighting | [email protected]page 2 / 2
PRODUCT MANUAL
COPYRIGHT BIA ©2019 V06.19
INSTALLATION INSTRUCTIONS
1. Before commencing installation, ensure the main power is
switched off.
2. Use the luminaire brackets to measure ceiling holes. Drill
holes into the installation surface and insert wall plugs.
3. Mount the bracket onto the prepared holes and secure with
the screws provided.
4. Connect the cables together. Ensure appropriate
waterproofing needs if required.
5. Loosen the nut screws on the sides to adjust the angle of the
luminaire, tighten to secure the angle.
6. Turn on main power.
Note: If necessary, silicone should be applied to wire entry points to
enforce IP rating.
DIAMENSION DIAGRAM
10W 20W
30W 50W
4
3
5
2
26.5mm135mm
125mm
10.5mm
Ø7mm
54mm
60mm
66mm
95mm
36.5mm190mm
189mm
8mm
Ø8mm
84mm
96mm
108mm
135mm
39.5mm238mm
233mm
10.5mm
Ø13mm
76mm
100mm
124mm
168mm
44.5mm298mm
284mm
10.5mm
126mm
150mm
174mm
210mm