BOSS ILLUMINATION CASTLE Series User manual

www.bia.lighting | [email protected]page 1 / 2
PRODUCT MANUAL
COPYRIGHT BIA ©2019 V06.19
Disclaimer: Please read these warranty
and installation instructions carefully
before installing the product.
BIA products are manufactured
and certied in accordance with all
mandatory Australian Standards.
All products must be installed by a
licensed electrician, in accordance
with relevant Australian Standards.
Technical data and information subject
to changes, visit our website for the
most updated version.
WARRANTY STATEMENT This product is covered by a 5 year replacement warranty.
BIA guarantees this product to be free of defects from the date of purchase for the stated period above. If product fails within the warranty period, BIA will x
or replace the product. This excludes any costs associated with the removal or installation of product. This warranty is subject to the terms and conditions stated
on www.bia.lighting. Failure to comply with installation guidelines will automatically void the warranty. Please retain purchase receipt. For more information on
warranty please visit www.bia.lighting/warranty
BIA reserves the right to change specications and other information, modify products and discontinue items without prior notication.
PRODUCT VARIANTS
POWER : 80W
100W
150W
200W
CCT : 3000K
6000K
PRODUCT SPECIFICATIONS
Input Voltage : 220-240VAC
Ambient Temperature : -10 to 45°C
Dimming : No
CASTLE
FLOOD LIGHT
Must be installed by
a licensed electrician.
Must be installed
in accordance with
relevant Australian
Standards.
ADDITIONAL INFORMATION
1. Luminaire covers in different designs and colours available.
2. This product is suitable for outdoor use.
3. If cleaning maintenance is required, use a clean microfibre cloth,
slightly dampened with a mild dilution of detergent that is PH
neutral, alcohol free and non-abrasive.
PARTS INCLUDED
LED
Luminaire
IP65
Mounting
Bracket &
Accessories

www.bia.lighting | [email protected]page 2 / 2
PRODUCT MANUAL
COPYRIGHT BIA ©2019 V06.19
INSTALLATION INSTRUCTIONS
1. Before commencing installation, ensure the main power is
switched off.
2. Use the luminaire brackets to measure ceiling holes. Drill
holes into the installation surface and insert wall plugs.
3. Mount the bracket onto the prepared holes and secure with
the screws provided.
4. Connect the cables together. Ensure appropriate
waterproofing needs if required.
5. Loosen the nut screws on the sides to adjust the angle of the
luminaire, tighten to secure the angle.
6. Turn on main power.
Note: If necessary, silicone should be applied to wire entry points to
enforce IP rating.
DIAMENSION DIAGRAM
80W
150W
100W 200W
4
3
5
2
252.5mm
359mm
28mm 312.5mm
125mm
150mm
175mm
87.5mm
286mm
438mm
35mm
13mm
143.5mm
180mm
216.6mm
366mm
97mm
506mm
364mm 108.5mm
15mm
Ø13mm
140mm
180mm
220mm
434mm
140mm
116mm401.5mm
484.5mm
581mm
180mm
220mm
Ø13mm