BOSS ILLUMINATION HALO User manual

www.bia.lighting | [email protected]page 1 / 2
PRODUCT MANUAL
COPYRIGHT BIA ©2019 V10.19
Disclaimer: Please read these warranty
and installation instructions carefully
before installing the product.
BIA products are manufactured
and certied in accordance with all
mandatory Australian Standards.
All products must be installed by a
licensed electrician, in accordance
with relevant Australian Standards.
Technical data and information subject
to changes, visit our website for the
most updated version.
WARRANTY STATEMENT This product is covered by a 2 year replacement warranty.
BIA guarantees this product to be free of defects from the date of purchase for the stated period above. If product fails within the warranty period, BIA will x
or replace the product. This excludes any costs associated with the removal or installation of product. This warranty is subject to the terms and conditions stated
on www.bia.lighting. Failure to comply with installation guidelines will automatically void the warranty. Please retain purchase receipt. For more information on
warranty please visit www.bia.lighting/warranty
BIA reserves the right to change specications and other information, modify products and discontinue items without prior notication.
PRODUCT VARIANTS
CCT : 3000K
4000K
PRODUCT SPECIFICATIONS
Input Voltage : 100-277 V
Ambient Temperature : -10 to 45°C
Dimming : No
Weight : 2.5kg
HALO
LED BOLLARD
Must be installed by
a licensed electrician.
Must be installed
in accordance with
relevant Australian
Standards.
ADDITIONAL INFORMATION
1. Cage must be installed prior to concrete work.
2. Please plan accordingly and allow for adequate drainage.
3. Luminaire base must be installed flushed against the surface.
4. Installation on uneven surfaces is not recommended.
5. Installation must be carried out with care to ensure the surface
of the luminaire is not scratched or damaged. Damaged
surfaces will result in material corrosion when exposed under
harsh weather conditions.
6. Please ensure luminaire cover is sealed.
7. If cleaning maintenance is required, use a clean microfibre cloth,
slightly dampened with a mild dilution of detergent that is PH
neutral, alcohol free and non-abrasive.
PARTS INCLUDED
CageBollard
IP55

www.bia.lighting | [email protected]page 2 / 2
PRODUCT MANUAL
COPYRIGHT BIA ©2019 V10.19
INSTALLATION INSTRUCTIONS
1. Before commencing installation, ensure the main power is
switched off.
2. Prepare in-ground hole size of 300mm³.
3. Lay conduit and set cage in place. Pour in concrete and fill up.
4. Prepare wiring when concrete has cured.
5. Place base plate over cage, secure with washer and nut.
6. Connect and waterproof all wiring.
7. Place bollard over base plate, secure with Allen key.
8. Turn on main power.
WARNING! All Wiring and connection points must be waterproofed
to the required IP rating.
800mm
Ø140mm Ø100mm
200mm
conduit
concrete
base plate cage
Ø13mm
DIAMENSION DIAGRAM
3
4
5
7
2