BOSS ILLUMINATION IRON User manual

www.bia.lighting | [email protected]page 1 / 3
PRODUCT MANUAL
COPYRIGHT BIA ©2019 V05.19
Disclaimer: Please read these warranty
and installation instructions carefully
before installing the product.
BIA products are manufactured
and certied in accordance with all
mandatory Australian Standards.
All products must be installed by a
licensed electrician, in accordance
with relevant Australian Standards.
Technical data and information subject
to changes, visit our website for the
most updated version.
WARRANTY STATEMENT This product is covered by a 5 year replacement warranty.
BIA guarantees this product to be free of defects from the date of purchase for the stated period above. If product fails within the warranty period, BIA will x
or replace the product. This excludes any costs associated with the removal or installation of product. This warranty is subject to the terms and conditions stated
on www.bia.lighting. Failure to comply with installation guidelines will automatically void the warranty. Please retain purchase receipt. For more information on
warranty please visit www.bia.lighting/warranty
BIA reserves the right to change specications and other information, modify products and discontinue items without prior notication.
PRODUCT VARIANTS
Power: 40W
80W
120W
160W
200W
240W
280W
CCT : 3000K
4000K
5000K
PRODUCT SPECIFICATIONS
Input Voltage : 100-240VAC
Ambient Temperature : -10 to 45°C
Dimming : No
IRON
STREET LIGHT
Must be installed by
a licensed electrician.
Must be installed
in accordance with
relevant Australian
Standards.
ADDITIONAL INFORMATION
1. This luminaire is not dimmable.
2. Luminaire installation angle is adjustable. Refer instructions
overleaf.
3. Installation must be carried out with care to ensure the surface of
the luminaire is not scratched or damaged. Damaged surfaces will
result in material corrosion when exposed under harsh weather
conditions.
4. Please ensure luminaire cover is sealed.
5. If cleaning maintenance is required, use a clean microfibre cloth,
slightly dampened with a mild dilution of detergent that is PH
neutral, alcohol free and non-abrasive.
PARTS INCLUDED
10m CableLED
Luminaire
IP66 IK0860mm

www.bia.lighting | [email protected]page 2 / 3
PRODUCT MANUAL
COPYRIGHT BIA ©2019 V05.19
INSTALLATION INSTRUCTIONS
A ADJUSTING THE ANGLE
1. Unscrew the top of the luminaire to
remove the cover.
2. Loosen the bolt screws and adjust the
spigot bracket by sliding it up or down.
3. Tighten the bolt screws to secure the
bracket.
B INSTALLATION
1. Ensure pole of the correct diametre has been installed/supplied.
2. Feed wiring cable through spigot. Cable should be terminated
within the pole and to the IP rating required.
3. Place luminare over spigot and slide it all the way in.
4. Tighten the screws to rmly secure luminaire.
4
12
3
2
1
1
3
1
1
+15º
0º
-15º

www.bia.lighting | [email protected]page 3 / 3
PRODUCT MANUAL
COPYRIGHT BIA ©2019 V05.19
DIAMENSION DIAGRAM
Weight
IRON 40 5.5kg
IRON 80 7.5kg
IRON 120 8.4kg
IRON 160 9.7kg
IRON 200 10.8kg
IRON 240 11.6kg
IRON 280 13.5kg
107mm107mm
107mm
107mm
107mm
107mm
300mm
900mm
107mm
300mm
981mm
300mm
495mm
300mm
576mm
300mm
657mm
300mm
738mm
300mm
819mm