BOSS ILLUMINATION MAGNA 24 User manual

www.bia.lighting | [email protected]page 3 / 2
PRODUCT MANUAL
COPYRIGHT BIA ©2020 V03.20
Disclaimer: Please read these warranty
and installation instructions carefully
before installing the product.
BIA products are manufactured
and certied in accordance with all
mandatory Australian Standards.
All products must be installed by a
licensed electrician, in accordance
with relevant Australian Standards.
Technical data and information subject
to changes, visit our website for the
most updated version.
WARRANTY STATEMENT This product is covered by a 5 year replacement warranty.
BIA guarantees this product to be free of defects from the date of purchase for the stated period above. If product fails within the warranty period, BIA will x
or replace the product. This excludes any costs associated with the removal or installation of product. This warranty is subject to the terms and conditions stated
on www.bia.lighting. Failure to comply with installation guidelines will automatically void the warranty. Please retain purchase receipt. For more information on
warranty please visit www.bia.lighting/warranty
BIA reserves the right to change specications and other information, modify products and discontinue items without prior notication.
PRODUCT VARIANTS
CCT : 3000K
4000K
6000K
RGB
Beam Angle: 10°
20°
40°
60°
PRODUCT SPECIFICATIONS
Power : 24W
Input Voltage : 24V DC
Ambient Temperature : -10 to 45°C
Dimming : PWM
MAGNA 24
INGROUND LIGHT
Must be installed by
a licensed electrician.
Must be installed
in accordance with
relevant Australian
Standards.
ADDITIONAL INFORMATION
1. This product can be installed directly into decking.
2. Canister is required for installation into concrete slab.
3. The face of the light tting must be installed ushed against the
surface.
4. Installation on uneven surfaces is not recommended.
5. Ensure the prepared cable is of the correct size and length.
6. Ensure all drivers, cables and joins are sufcient and installed to
the required IP rating.
7. Adequate drainage must be prepared underneath the light/
canister.
8. If cleaning maintenance is required, ensure power is off, use a
clean microbre cloth, slightly dampened with a mild dilution of
detergent that is PH neutral, alcohol free and non-abrasive.
PARTS INCLUDED
SOLD SEPARATELY
Driver Canister
Inground
Light
225mm IP68 IK10
Stainless
Steel
316

www.bia.lighting | [email protected]page 4 / 2
PRODUCT MANUAL
COPYRIGHT BIA ©2020 V03.20
DRIVER
CONTROLLER
+
-
+
RGBW RGBW RGBW
-
+
-
INSTALLATION INSTRUCTIONS
A DIRECT INSTALLATION INTO DECKING
1. Before commencing installation, ensure the main power is
switched off.
2. Measure and cut hole to 225mm.
3. Lay conduit and prepare wiring.
4. Connect and waterproof all wiring.
5. Hold the clips and gently push luminaire into place. The face of
the luminaire must be ushed against the installed surface.
6. Secure with screws.
B INSTALLING INTO A CANISTER
1. Before commencing installation, ensure the main power is
switched off.
2. Canisters are to be installed prior to concrete work. Please plan
accordingly and allow for adequate drainage.
3. Secure canisters into intended position. Lay conduit and prepare
wiring.
4. Connect and waterproof all wiring.
5. After the concrete has cured, install luminaire by holding the clips
and gently push luminaire into place. The face of the luminaire
must be ushed against the installed surface.
WARNING! all wiring and connection points must be waterproofed to
the required IP rating.
DIAMENSION DIAGRAM
5
6
4
4
3
2
225mm
24V single
conduit
24V RGB
canister
55mm
100mm
248mm 220mm
204mm 204mm
Ø6.5mm