BOSS ILLUMINATION THOR PLUS 225 User manual

www.bia.lighting | [email protected]page 1 / 2
PRODUCT MANUAL
COPYRIGHT BIA ©2020 V05.20
Disclaimer: Please read these warranty
and installation instructions carefully
before installing the product.
BIA products are manufactured
and certied in accordance with all
mandatory Australian Standards.
All products must be installed by a
licensed electrician, in accordance
with relevant Australian Standards.
Technical data and information subject
to changes, visit our website for the
most updated version.
WARRANTY STATEMENT This product is covered by a 3 year replacement warranty.
BIA guarantees this product to be free of defects from the date of purchase for the stated period above. If product fails within the warranty period, BIA will x
or replace the product. This excludes any costs associated with the removal or installation of product. This warranty is subject to the terms and conditions stated
on www.bia.lighting. Failure to comply with installation guidelines will automatically void the warranty. Please retain purchase receipt. For more information on
warranty please visit www.bia.lighting/warranty
BIA reserves the right to change specications and other information, modify products and discontinue items without prior notication.
PRODUCT VARIANTSPRODUCT SPECIFICATIONS
Power : 26W / 36W
CCT Changeable : 3000K / 4000K / 5000K
Input Voltage : 220-240VAC
Ambient Temperature : -20 to 40°C
Dimming : No
THOR PLUS 225
COMMERCIAL DOWNLIGHT
Must be installed by
a licensed electrician.
Must be installed
in accordance with
relevant Australian
Standards.
ADDITIONAL INFORMATION
1. This product comes with two switches at the back of the
heatsink, one to switch between different colour temperatures,
another to switch between wattages.
2. This product is suitable for outdoor under cover use.
2. Luminaire must be installed with supplied designated driver.
3. If cleaning maintenance is required, use a clean microfibre cloth,
slightly dampened with a mild dilution of detergent that is PH
neutral, alcohol free and non-abrasive.
PARTS INCLUDED
205mm IP44
AU Plug Driver
26W
36W
LED
Downlight

www.bia.lighting | [email protected]page 2 / 2
PRODUCT MANUAL
COPYRIGHT BIA ©2020 V05.20
INSTALLATION INSTRUCTIONS
1. Before commencing installation, ensure the main power is
switched off.
2. Measure and cut ceiling hole to 205mm.
3. Remove back cover to select desired wattage
and colour temperature.
4. Put the cover back on. Do not leave the switches uncovered.
5. Connect plug to 240VAC power socket.
6. Push clips backwards, hold in place and insert luminaire into
prepared ceiling hole. Luminaire clips will spring into place.
7. Turn on main power.
DIAMENSION DIAGRAM
205mm
203mm
70mm
196mm
Ø225mm
CLEARANCE TABLE
Scenario: Uncovered luminaire
• Avoid placing insulation over luminaire.
• Do not cover the driver.
• Clearance between luminaire, driver and building materials should
meet the recommendations above.
Min. 50mm Min. 50mm
LED Driver
Combustible
Building
Element
Combustible Building Element
Thermal
Insulation
Min. 20mm
POWER
ON 26W
1 36W
POWER
ON
ON
ON
1
1
1 2
CCT
ON 2 3000K
ON ON 4000K
1 ON 5000K
CCT
5
6 6
ON
1 2
3