BOSS ILLUMINATION AERO User manual

www.bia.lighting | [email protected]page 1 / 2
PRODUCT MANUAL
COPYRIGHT BIA ©2020 V11.20
WARRANTY STATEMENT This product is covered by a 5 year replacement warranty.
BIA guarantees this product to be free of defects from the date of purchase for the stated period above. If product fails within the warranty period, BIA will x
or replace the product. This excludes any costs associated with the removal or installation of product. This warranty is subject to the terms and conditions stated
on www.bia.lighting. Failure to comply with installation guidelines will automatically void the warranty. Please retain purchase receipt. For more information on
warranty please visit www.bia.lighting/warranty
BIA reserves the right to change specications and other information, modify products and discontinue items without prior notication.
PRODUCT VARIANTS
Power : 30W
50W
80W
100W
CCT : 3000K
4000K
5000K
Dimming: No
1-10V
DALI
PRODUCT SPECIFICATIONS
Beam Angle : Type II
Input Voltage : 240V AC
Operating Temperature : -10 to 40°C
Weight : 4kg
Material : Aluminium
AERO
STREET LIGHT
Must be installed by
a licensed electrician.
Must be installed
in accordance with
relevant Australian
Standards.
ADDITIONAL INFORMATION
1. NEMA socket is compatible with third party NEMA outdoor
lighting controllers.
2. If cleaning maintenance is required, disconnect from mains
supply and allow luminaire to cool. Use a clean microbre cloth,
slightly dampened with a mild dilution of detergent that is PH
neutral, alcohol free and non-abrasive.
3. Do not use harsh chemicals or solvents. Do not use high pressure
cleaners.
4. Care must be taken during installation and maintenance to
prevent accidental damage to the surface of the luminaire. These
damages may result in corrosion.
PARTS INCLUDED
Luminaire
with
integrated
driver
IP65 IK0860mm
OPTIONAL COMPATIBLE PARTS sold separately
Photocell
Disclaimer: Please read this product
manual carefully before installing the
product.
Warranty is void if installation
guidelines are disregarded, if the
product has been modied, or if
damage is caused by misuse or
improper installation.
Images, drawings and diagrams are for
illustrative purposes only.
BIA products are manufactured
and certied in accordance with all
mandatory Australian Standards.
Technical data and information subject
to changes. Please visit our website
for latest version.
x1
NEMA 7-pin
base
NEMA 3-pin
blank module

www.bia.lighting | [email protected]page 2 / 2
PRODUCT MANUAL
COPYRIGHT BIA ©2020 V11.20
INSTALLATION INSTRUCTIONS
1. Ensure pole of the correct diameter has been supplied/installed.
2. Feed wiring cable through spigot. Cable should be terminated
within the pole.
3. Place luminaire over spigot and slide it all the way in.
4. Tighten the screws to rmly secure luminaire.
IMPORTANT NOTE: All connections made must be
waterproofed to the appropriate IP rating for the application.
Warranty is void if connection IP ratings are not met.
DIMENSION DIAGRAM
472mm
233mm 163mm 78mm
with photocell without photocell
12
3
4
1
2
LUMINAIRE
CONTROLLER
INSTALLATION
1. Twist anti-clockwise to remove
the blank module.
2. Twist in the luminaire controller,
clockwise until it clicks.