Breville BSG540 User manual

the Toast & Melt™ Sandwich Press
Instruction Book - BSG520/BSG540

2
BREVILLE
RECOMMENDS
SAFETY FIRST
At Breville we are very safety
conscious. We design and
manufacture consumer
products with the safety of you,
our valued customer, foremost
in mind. In addition we ask
that you exercise a degree of
care when using any electrical
appliance and adhere to the
following precautions.
IMPORTANT
SAFEGUARDS
READ ALL
INSTRUCTIONS BEFORE
USE AND SAVE FOR
FUTURE REFERENCE
• Carefully read all
instructions before
operating the sandwich
press for the first time and
save for future reference.
• Remove and safely discard
any packaging material and
promotional stickers before
using the sandwich press for
the first time.
• To eliminate a choking
hazard for young children,
remove and safely discard
the protective cover fitted
to the power plug of this
appliance.
• Do not place the sandwich
press near the edge of
a bench or table during
operation. Ensure that the
surface is level, clean and
free of water.
• Keep the sandwich press
clear of walls, curtains and
other heat or steam sensitive
materials.
• The sandwich press must be
used on a properly grounded
outlet. If you are not sure
if the power outlets are
properly grounded, please
consult your electricians.
• Do not, under any
circumstances, modify
the power plug or use an
adapter.
• Do not place the sandwich
press on or near a hot gas or
2 Breville Recommends Safety First
6 Components
7 Functions
8 Tips
9 Care & Cleaning
Contents

3
electric burner, or where it
could touch a heated oven.
Use the sandwich press well
away from walls.
• Provide adequate space
above and on all sides for
air circulation around the
sandwich press.
• Do not place the sandwich
press on any surface that
may be affected by heat.
The use of a heat resistant
matt is recommended on
these surfaces.
• Do not use on a sink
drain board.
• Always use the sandwich
press on a dry, level surface.
• Do not touch hot surfaces.
Use the handles to lift
and open the top plate.
Take care when using the
Adjustable Grilling Height
Control.
• Do not leave the sandwich
press unattended when
in use.
• The outer housing of the
sandwich press may be hot
during and after use. Please
do not touch hot surfaces.
Always keep the power cord
of this products, and those
of other appliances nearby,
clear from the housing.
• The sandwich press is
not suitable to be used
in a small appliance
enclosure. Ensure to
leave adequate space all
around the sandwich press.
Minimum space of 10cm is
recommended.
• Do not place anything on
top of the sandwich press
when the lid is closed, when
in use and when stored.
• Always switch the sandwich
press off at the power outlet,
then unplug the power
cord and to allow to cool,
if appliance is not in use,
before cleaning, before
attempting to move the
appliance, disassembling,
assembling and when
storing the appliance.
• Do not use harsh abrasives,
caustic cleaners or oven
cleaners when cleaning the
sandwich press.
• Keep the exterior housing
and the non-stick cooking
plates clean. Follow the
cleaning instructions
provided in this book. Refer
to Care, Cleaning and
Storage (Page 9).

4
• This appliance is not
intended to be operated by
means of an external timer
or separate remote control
system.
IMPORTANT
SAFEGUARDS FOR
ALL ELECTRICAL
APPLIANCES
• Fully unwind the power
cord before use.
• Connect only to a 230V or
240V power outlet.
• Do not let the power cord
hang over the edge of a
bench or table, touch hot
surfaces or become knotted.
• To protect against electric
shock, do not immerse the
power cord, power plug
or appliance in water or
any other liquid or allow
moisture to come in contact
with the part, unless it
is recommended in the
cleaning instructions.
• Children should be
supervised to ensure that
they do not play with the
appliance.
• It is recommended to
regularly inspect the
appliance. To avoid a
hazard do not use the
appliance if power cord,
power plug or appliance
becomes damaged in any
way. Return the entire
appliance to the nearest
authorised Breville Service
Centre for examination
and/or repair.
• The appliance is not
intended for use by persons
(including children) with
reduced physical, sensory
or mental capabilities,
or lack of experience
and knowledge, unless
they have been given
supervision or instruction
concerning use of the
appliance by a person
responsible for their safety.
• Any maintenance other
than cleaning should be
performed at an authorised
Breville Service Centre.
• This appliance is for
household use only. Do
not use this appliance
for anything other than
its intended use. Do not
use in moving vehicles or
boats. Do not use outdoors.
Misuse may cause injury.

5
FOR HOUSEHOLD USE ONLY
SAVE THESE INSTRUCTIONS
IMPORTANT
Fully unwind the power
cord from the cord storage
facility before use.
• The installation of a
residual current device
(safety switch) is
recommended to provide
additional safety protection
when using electrical
appliances. It is advisable
that a safety switch with a
rated residual operating
current not exceeding
30mA be installed in the
electrical circuit supplying
the appliance. See your
electrician for professional
advice.
• During electrical storms,
the appliance should be
disconnected from the
power source at the wall
socket to prevent any
electrical surges that may
arise during the storm and
which may inadvertently
cause damage to the
appliance and its electronic
componentry.
• Always turn the appliance
to the off position, switch
off at the power outlet and
unplug at the power outlet
when the appliance is not
in use.
• Before cleaning, always
turn the appliance to the
off position, switch off at
the power outlet, unplug
at the power outlet and
remove the power cord,
if detachable, from the
appliance and allow all
parts to cool.
• Do not place this appliance
on or near a heat source,
such as hot plate, oven or
heaters.
• Position the appliance at
a minimum distance of
20cm away from walls,
curtains and other heat or
steam sensitive materials
and provide adequate space
above and on all sides for
air circulation.

6
Components
D
I
H
G
A
F
E
C
B
A. 2200W of power (BSG540)
2000W of power (BSG520)
For fast heat up and quick toasting.
B. Heavy duty die-cast arms
For durability and strength.
C. Floating top plate
Automatically adjusts to thick or
thin sandwiches.
D. Flat non-stick cooking plates
For extra crispy toasted results.
E. ‘Power’ and ‘Ready’ lights
Indicate when the sandwich press is
heating or ready to use.
F. Adjustable height control clip
With 4 settings for making open sandwich
melts, toasted sandwiches and everything
in between.
G. Safety locking storage clip
To lock plates closed for upright storage.
H. Non-slip feet
I. Convenient cord wrap in base

7
Functions
BEFORE FIRST USE
Remove any promotional materials and
packaging materials before use. Check that the
cooking plates are clean and free of dust.
If necessary, wipe over with a damp cloth.
When using the sandwich press for the
first time you may notice a fine smoke haze.
This is caused by the heating of some of the
components. There is no need for concern.
TOASTED SANDWICH
1. Insert the power plug into a 230V or 240V
power outlet and then turn the power ON.
The red ‘POWER’ light will illuminate.
2. Allow the sandwich press to pre-heat with
the top cooking plate in the closed position
until the green ‘READY’ light illuminates.
3. During this time, prepare the sandwich.
When the sandwich press has pre-heated,
place the sandwich onto the bottom
cooking plate. Always place sandwiches
towards the rear of the bottom
cooking plate.
4. Close the top cooking plate. The top
cooking plate has a floating hinge that
is designed to evenly press down on the
sandwich (see Fig 1).
Fig. 1
5. Toasting should take approximately
5–8 minutes. Exact toasting time will be a
matter of taste. It will also depend on the
type of bread and type of filling used.
6. When the sandwich is cooked, use the
handle to open the sandwich press and raise
the top cooking plate. Remove sandwich
with the help of a plastic or wooden spatula.
Never use metal tongs or a knife as these
can cause damage to the non-stick coating.
NOTE
• Always allow the sandwich press to pre-heat
until the green ‘READY’ light illuminates.
• The safety locking storage clip should not be
used to clamp down the top cooking plate
when the sandwiches are in the sandwich
press. The weight of the top cooking plate
will gradually press down the sandwich
during the cooking process.
• When using the sandwich press for the
first time you may notice a fine smoke haze.
This is caused by the heating of some of the
components. There is no need for concern.
CAUTION
HOT SURFACE - The temperature of
accessible surfaces may be high when the
appliance is operating and for some time
after use.
Fully unwind the cord from the cord storage
facility before use.
Your sandwich press features an Adjustable
Height Control feature which allows you to fix
the top plate to a range of positions above the
bottom plate. This allows your sandwich press
to be used as an open toaster ideal for toasting
open sandwich melts. It can also be used for
toasting sandwiches where you don’t need to
apply the weight of the top plate.

8
OPEN SANDWICH MELTS
1. Allow the sandwich press to pre-heat until
the green ‘READY’ light illuminates.
2. Place sandwich to be melted on
bottom plate.
3. Move the Adjustable Height Control clip on
the right hand side of the sandwich press to
the desired height (see Fig 2).
4. Slowly lower the top plate until it rests on
the Adjustable Height Control clip.
5. The top plate will radiate the desired heat to
melt ingredients such as cheese.
6. Toasting melts should take approximately
3–4 minutes. However exact toasting time
will be a matter of taste. It will also depend
on the height of the top plate.
Adjustable Height Control
Toasts or melts any bread
thickness in minutes.
Fig. 2
Fig. 3
NOTE
The Adjustable Height Control can be moved
to accommodate thick or thin melts by sliding
the clip forwards or backwards along the arm.
Tips
BREAD
Most types of bread can be used; white,
wholemeal, kibbled wheat, wholegrain, raisin
loaf and so on. The sandwich press is ideal for
toasting foccacia, Turkish bread, baguettes
as well as bread rolls. Raisin bread, brioche or
other sweet breads which contain a high sugar
content will tend to brown quicker.
FILLINGS
Try to use canned or pre-cooked fruit as
fresh fruit may give off excessive juices when
heated. Be careful when biting into sandwiches
containing fillings such as cheese and tomato
or jam as they retain heat and can burn if eaten
too quickly.
TOASTING BREAD
The unique flat plate design makes the
sandwich press ideal for toasting plain breads,
and Turkish bread, without any fillings or
spreads. Try toasting Turkish Bread with jams
for a great alternative to standard breads
at breakfast.
FAT FREE SNACKS
Due to the non-stick flat plate design, it is not
necessary to use any butter or margarine on
the outside of your toasted snacks.

9
Care & Cleaning
Before cleaning, switch the power off at the
power outlet and then remove the power plug.
Allow your sandwich press to cool before
cleaning. The appliance is easier to clean when
slightly warm.
Always clean your sandwich press after each
use to prevent a build up of baked-on foods.
Wipe cooking plates with a soft cloth. If cooked
on food is not removed by this method reheat
the unit for 1–2 minutes, then brush with a
little oil or melted butter. Allow to stand for five
minutes then wipe with a damp cloth.
NOTE
• The cooking plates are coated with a
non-stick surface, do not use abrasives.
• Do not use spray-on non-stick coatings as
this will affect the performance of the
non-stick surface on the cooking plates.
STORAGE
To store your sandwich press:
1. Switch off at power outlet and unplug power
cord from the wall.
2. Allow the sandwich press to fully cool.
3. Slide the Adjustable Height Control
towards the front handle to the ‘LOCK’
position so that the top and bottom cooking
plates are locked together (see Fig 4).
Fig. 4
4. Wrap the power cord in the cord storage
area below the appliance (see Fig 5).
Fig.5
5. Store on a flat, dry, level surface.
NOTE
The storage clip should not be used to clamp
down the top plate when sandwiches are in
the sandwich press.
WARNING
Do not immerse any part of the sandwich press
in water or any other liquid.

10
Notes