Breville PolyScience Sous Vide CRC-5AC1B User manual

USER’S GUIDE
PRECISE TEMPERATURE COOKING SYSTEM™

IMPORTANT SAFEGUARDS.

IMPORTANT: Your Sous Vide Professional is equipped
with an automatic over-temperature safety that will
disable the heater in the event of a heater fault. If this
safety cannot be reset, the unit must be sent back to
PolyScience.
!
IMPORTANT: COUNTERTOP PROTECTION
Some countertop materials may not be able to withstand
the prolonged exposure to heat required for sous vide
cooking. To safeguard against damage to your countertop,
PolyScience recommends that you always place your
cooking vessel on a trivet or other insulating material before
you begin heating the cooking liquid.
!
IMPORTANT: Your Sous Vide Professional is also equipped
with a float switch that disables the heater and pump in the
event that the liquid level in the cooking vessel drops too
low. If the Circulator will not restart once a proper liquid
level is restored, the unit must be sent back to PolyScience.
!
SAVE THESE INSTRUCTIONS.

1
Attach your Sous Vide
Professional to the
cooking vessel
2
Fill the vessel with
tap water and cover
with plastic wrap or lid
3Connect the power cord
to an electrical outlet
4Turn the Sous Vide
Professional “ON”
5
Press the Menu button
to access the set point
menu
Menu
Button

6Enter desired cooking
temperature
7Press the RUN button
Run
Button
Increase and
decrease
value buttons

IMPORTANT: The water level in
the cooking vessel will rise as
food is added. Be sure to allow
for this displacement when
placing liquid in the vessel.
!
WARNING: Make certain that the electrical outlet is
the same voltage and frequency as your Circulator. The
correct voltage and frequency are indicated on a label on
the back of the unit. The use of extension cords is not
recommended.

IMPORTANT: Always allow the cooking liquid to reach the
set point temperature before adding the sous vide cooking
pouches to the cooking vessel. For optimal heating and
performance, cover the cooking vessel with plastic wrap or
a lid (DO NOT COVER THE CIRCULATOR).
!
IMPORTANT: The cooking temperature cannot be set while
the Circulator is heating or circulating the cooking liquid.
You must first place it in Standby by pressing .
!
Setting Cooking Temperature
Cooking temperature may be set and displayed in either °F or °C.

IMPORTANT: The timer cannot be set while the Circulator
is heating or circulating the cooking liquid. You must first
place it in Standby by pressing .
!

WARNING: To avoid the potential for burns, allow the
Circulator to cool to room temperature before removing it
from the cooking vessel.
WARNING: Never immerse the Circulator’s controls or
display in water or other liquids or place under running
water. Do not clean the unit in a dishwasher.
!

Pump Impeller

WARNING: Never operate your Circulator without the
protective cover in place.
!
WARNING: To avoid the potential for burns, allow the
Circulator to cool to room temperature before removing it
from the cooking vessel.