Breville Juice Fountain Crush User manual

www.breville.com.au
Breville is a registered trademark of Breville Pty. Ltd. A.B.N. 98 000 092 928.
Copyright Breville Pty. Ltd. 2012.
Due to continued product improvement, the products illustrated/photographed
in this brochure may vary slightly from the actual product.
BJS600 Issue - A12
Australian Customers
Mail: PO Box 22
Botany NSW 2019
AUSTRALIA
Phone: [phone]
Fax: [phone]
Email: Customer Service:
[e-mail]
New Zealand Customers
Mail: Private Bag 94411
Botany Manukau 2163
Auckland NEW ZEALAND
Phone: [phone]
Fax: [phone]
Email: Customer Service:
[e-mail]
Breville Customer Service Centre

BJS600
the Juice Fountain™Crush
Instruction Booklet

CONGRATULATIONS
on the purchase of your Breville Product

3
CONTENTS
4Breville recommends safety first
6Know your Breville product
8Assembling your Breville product
12 Operating your Breville product
15 Disassembling your
Breville product
17 Care & cleaning
19 Troubleshooting
23 Recipes

4
BREVILLE RECOMMENDS SAFETY FIRST
At Breville we are very safety conscious. We design and manufacture consumer products
with the safety of you, our valued customer, foremost in mind. In addition we ask that you
exercise a degree of care when using any electrical appliance and adhere to the following
precautions.
READ ALL INSTRUCTIONS
BEFORE USE AND SAVE FOR
FUTURE REFERENCE
• Carefully read all instructions before
operating the appliance for the first time
and save for future reference.
• Remove and safely discard any
packaging materials and promotional
labels before using the appliance for the
first time.
• To eliminate a choking hazard for young
children, remove and safely discard the
protective cover fitted to the power plug
of this appliance.
• To protect against electrical shock, do
not immerse the power cord, power
plug or motor base in water or any other
liquid.
• Always use the appliance on a dry,
level surface.
• Do not use the appliance on a sink
drain board.
• Do not place the appliance near the edge
of a bench or table during operation.
Vibration during operation may cause
the appliance to move.
• Do not place the appliance on or near
a hot gas or electric burner, or where it
could touch any other source of heat.
• Unwind the power cord fully before use.
• Do not allow the power cord to hang
over the edge of a table or counter, touch
hot surfaces or become knotted.
• Always ensure the appliance is
completely assembled before
connecting to the power outlet and
operating. The appliance will not turn on
unless properly assembled. Follow the
instructions provided in this book.
• Always avoid contact with moving parts.
• Strictly follow the care and cleaning
instructions described in this book.
• This appliance is for household use only.
Do not use the appliance for anything
other than its intended purpose as
described in this book. Do not use
outdoors. Do not use in moving vehicles
or boats.
• The use of attachments not sold or
recommended by Breville may cause fire,
electric shock or injury.
• Do not leave the appliance unattended
when in use.
• Do not operate the juice extractor
without the pulp and juice container
in place.
• Do not use the juice extractor if the
juicing screw is damaged.
• Do not push produce into the feed chute
with your fingers. Always use the food
pusher provided.
• Do not juice stone fruit unless seeds
and/or stones have been removed.
• Always switch the juice extractor off
after each use. Ensure the motor stops
completely and unplug the power cord
from the wall outlet before attempting
to move the appliance, before cleaning,
disassembling, assembling and when
storing the appliance.
• Do not operate the machine longer than
20 seconds before inserting ingredients.
IMPORTANT SAFEGUARDS

5
BREVILLE RECOMMENDS SAFETY FIRST
5
IMPORTANT SAFEGUARDS FOR
ALL ELECTRICAL APPLIANCES
• Fully unwind the power cord before use.
• Do not let the power cord hang over
the edge of a bench or table, touch hot
surfaces or become knotted.
• To protect against electric shock do not
immerse the power cord, power plug or
appliance in water or any other liquid.
• The appliance is not intended for use
by persons (including children) with
reduced physical, sensory or mental
capabilities, or lack of experience and
knowledge, unless they have been given
supervision or instruction concerning
use of the appliance by a person
responsible for their safety.
• Children should be supervised to ensure
that they do not play with the appliance.
• It is recommended to regularly inspect
the appliance. To avoid a hazard do not
use the appliance if power cord, power
plug or appliance becomes damaged in
any way. Return the entire appliance to
the nearest authorised Breville Service
Centre for examination and/or repair.
• Any maintenance other than cleaning
should be performed at an authorised
Breville Service Centre.
• This appliance is for household use only.
• Do not use this appliance for anything
other than its intended use. Do not use
in moving vehicles or boats. Do not use
outdoors. Misuse may cause injury.
• The installation of a residual current
device (safety switch) is recommended
to provide additional safety protection
when using electrical appliances. It
is advisable that a safety switch with
a rated residual operating current
not exceeding 30mA be installed in
the electrical circuit supplying the
appliance. See your electrician for
professional advice. SAVE THESE
INSTRUCTIONS

KNOW
your Breville Product

7
KNOW YOUR BREVILLE PRODUCT
A. Food Pusher
B. Hopper And Lid
C. Juicing Screw
D. Filter Basket
E. Scraper Wiper
F. Pulp Container
B
A
G. Motor Base
H. Juicing Jug
I. ON | OFF | REVERSE
J. Juicing Bowl
K. Filter Cleaning Brush
J
I
G
C. D. K. E.
F
H

ASSEMBLING
your Breville Product

9
ASSEMBLING YOUR BREVILLE PRODUCT
BEFORE FIRST USE
Before using the juice extractor for the
first time, remove and safely discard any
packaging material and promotional labels.
Ensure the power cord is unplugged from
the wall outlet.
Wipe the motor base with a damp cloth.
Dry thoroughly.
Wash the juicing bowl, filter basket, juicer
cover, food pusher, juice jug and pulp
container in warm soapy water with a
soft cloth or nylon brush. Rinse and dry
thoroughly.
NOTE
These parts are not dishwasher safe.
1. Place the motor base on a flat dry
surface such as a counter-top. Ensure the
power cord is unplugged from the
wall outlet.
2. Underneath the filter bowl is the pulp
extraction silicon, which is used to
remove the pulp from the spout of the
juicing bowl. Ensure that the silicon is
firmly inserted into the juicing spout.
3. Place the juicing bowl on top of the
motor base. Align the arrows to the
ALIGN position then turn slightly
clockwise to the ALIGN/LOCK (closed)
position.
4. Assemble the filter basket into the
scraper wiper then place this assembly
in to the juicing bowl.
5. Note that the orange dot on the filter
needs to align with the orange dot on
the juicing bowl and motor base. Ensure
that the filter basket is completely
pushed down.

10
8. Ensure that the hopper is placed on the
feed chute. Place the food pusher into
the hopper.
9. Place the pulp container supplied into
position by tilting slightly and placing
under the pulp spout.
NOTE
To minimize clean up, place a produce
bag into the pulp container to collect
the pulp.
ASSEMBLING YOUR BREVILLE PRODUCT
6. Place the juicing screw into the filter
basket. Ensure that the juicing screw is
in position by pressing down on it, and
feel it click into place.
7. Place the lid on to the juicing bowl.
Align the orange dot on the lid with the
orange dot on the motor base and turn
clockwise to the closed position. The lid
will click into position.

11
ASSEMBLING YOUR BREVILLE PRODUCT
10. Place the juice jug under the juicer
spout; ensure that it is placed in position
under the spout.

OPERATING
your Breville Product

13
6. With the motor running gently guide
food down the feed chute. To extract the
maximum amount of juice, always push
the food pusher down slowly.
NOTE
Do not exert excess pressure, the fruit
or vegetable should almost be pulled
down by the screw.
NOTE
If the fruit or vegetables become
jammed in the screw and the juicer
stops operating press the OFF button
to the center. Ensure that the juicer
comes to a complete stop. Press the
REVERSE button and hold it until the
fruit or vegetables become dislodged.
NOTE
The screw will move in reverse and
release the food that is caught in the
screw. Once the food is released, press
the ON button and start juicing again.
IMPORTANT
Do not load the feed chute with food
until the motor is running.
OPERATING YOUR BREVILLE PRODUCT
OPERATING THE BREVILLE JUICE
FOUNTAIN CRUSH™
1. Wash and prepare your selection of fruit
and/or vegetables: Fruits with hard or
inedible skins such as citrus fruit and
melons should be peeled before juicing.
Pineapple can be juiced with or without
the rind removed. Fruits with pits, hard
seeds or stones such as nectarines,
peaches, mangoes, apricots, plums and
cherries must be pitted before juicing.
2. Ensure the juice extractor is correctly
assembled with the juice jug and pulp
container is under the spout.
NOTE
As a safety precaution, the juicer
will not operate if it has not been
assembled correctly.
3. Plug the power cord into a 230/240V
power outlet.
4. Cut fruit and vegetables into pieces that
will fit down the feed chute.
NOTE
As a guide, apples should be cut in
to quarters.
5. Push the ON button.

7. As the fruits and vegetables are
processed, juice will flow into the
juice jug and the separated pulp will
accumulate in the pulp container.
NOTE
The pulp container can be emptied
during juicing by turning the juicer
to the off position and removing the
pulp container. Replace the empty
pulp container into position before
continuing to juice.
WARNING
Do not operate juicer longer than 20
seconds before inserting ingredients.
8. Immediately after use, slowly pour a
glass of water down the feed chute.
Ensure that there is a separate jug under
the spout as the water will pour directly
into the juice jug that you juiced into.
This is a cleaning aspect and will help
when cleaning the filter basket.
NOTE
If you are making different fruit juices
you can pour a glass of water (about
6oz) in between the different juices
to rinse any left over flavors. It is not
always necessary to completely clean
the juicer in between making multiple
juices.
OVERLOAD PROTECTION
This protection device safeguards against
overloading the motor with excessive loads.
If overloading occurs, the motor will stop.
The overload protection will automatically
de-activate the motor. When this occurs,
unplug the power cord from the wall outlet
and allow the appliance to cool for at least 1
hour. Then reconnect the power cord to the
wall outlet. Then recommence normal use.
OPERATING YOUR BREVILLE PRODUCT
14

15
PAGE HEADER
DISASSEMBLING
your Breville Product

DISASSEMBLING YOUR BREVILLE PRODUCT
1. Ensure the juicer is turned off and the
power cord is unplugged from the power
outlet.
2. Remove the pulp container and
juicing jug.
3. Remove the lid by turning it to the open
position (anti-clockwise).
4. The juice bowl, scraper wiper, filter
basket and juicing screw can all be
removed together. Grip the juice bowl
and turn to the open position
(anti-clockwise) slightly, it will click
out of position. This is a very small
movement. The juicing bowl and all the
internals can now be lifted off the motor
base for cleaning.
WARNING
The juicing screw is a heavy object.
Take care when removing the juicing
screw. Be careful not to drop the
juicing screw.
16

PAGE HEADER
CARE & CLEANING

18
CARE & CLEANING
Always ensure that the juicer is turned off
and the power cord is unplugged from the
power outlet before cleaning, disassembling
or assembling and storing the appliance.
1. Immediately after each use, use the
provided nylon brush to thoroughly
clean the fine mesh holes of the filter
basket. Brush the inside of the filter
basket under running water, holding it
up towards the light to ensure the fine
mesh holes are not blocked.
2. Use the filter brush provided with the
juicer. This brush has been specially
designed to clean the filter basket.
Simply place the filter basket inside the
brush and under running water twist the
brush left and right to remove the pulp
from the filter basket. You will need to
use the small brush provided to clean
the inside of the filter basket, this should
also be done under running water.
If the holes are blocked, soak the filter
basket in hot water with 10% lemon juice
to loosen the blocked holes.
TIP
If the filter basket cannot be cleaned
immediately after use, soak the filter
basket in hot soapy water immediately
after juicing is complete. If pulp is left
to dry on the filter basket, it may clog
the fine mesh holes, thereby lessening
the effectiveness of the juicer. Do not
soak the filter basket in bleach.
3. Wash the juice bowl, scraper wiper,
juicing screw, pulp container and juicing
jug in warm soapy water with the small
nylon brush provided or a soft cloth.
Rinse and dry thoroughly.
NOTE
Do not place any part of the juicer in
the dishwasher.
TIP
Discoloration of the plastic parts
may occur with brightly colored fruit
and vegetables. To help prevent this,
wash parts immediately after use. If
discoloration does occur, the plastic
parts can be soaked in 10% lemon
juice and water or they can be cleaned
with a non abrasive cleaner. Do not
soak the filter basket in bleach. Do not
soak the motor base.
4. Wipe the motor base with a soft damp
cloth and dry thoroughly. Do not use
abrasive scouring pads or cleaners when
cleaning the motor base as these may
scratch the surface. Wipe any excess
food particles from the power cord.

PAGE HEADER
TROUBLESHOOTING