Brinsea Chick Safe eco User manual

1
Important! Install the ChickSafe Eco and attach the door BEFORE installing batteries.
Failure to observe this may cause incorrect operation and possible damage. (See page 3).
The ChickSafe is supplied pre-set to be attached to a FULLY OPEN DOOR. Failure to
observe this will cause incorrect operation and possible damage. (See page 3).
Please read these instructions carefully before setting up your ChickSafe Eco to achieve best results and keep these
instructions safe for future reference.
To register your new Brinsea product and qualify for your free 3 year warranty please visit www.brinsea.com within
30 days of purchase and follow the link on the Brinsea home page. The serial number may be found on the box
and inside the battery compartment. Sign up for the Brinsea newsletter to receive the latest news and information.
Warning - Risk of injury! Keep fingers clear of moving door and cord. Motor may start without warning.
Ensure the maximum door weight of 8lbs (4kg) is not exceeded as this will cause damage to the motor
and invalidate the warranty! Note that wooden doors are heavier when wet.
The maximum door lifting height is 15” (400mm). Do not exceed this as operation will be incorrect and
the cord may become detached.
Check the sliding door to make sure it runs smoothly and reliably both upwards and downwards. The
ChickSafe uses gravity alone to close the door.
To mount the ChickSafe further away from the door, an additional length of cord may be attached. For
helpful information see our ChickSafe ‘Frequently Asked Questions’page at www.brinsea.com
This appliance can be used by children aged from 8 years and above and persons with reduced physical,
sensory or mental capabilities or lack of experience and knowledge if they have been given supervision
or instruction concerning use of the appliance in a safe way and understand the hazards involved.
Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children
without supervision.
Installation and
Operating Instructions
D
A
A
2
Tools needed for installation:
- Screwdriver (cross head PZ1)
- Drill with a 1/8” (3mm) diameter
drill bit, or bradawl
- Tape measure
Caution! - Please Note:
•Use only alkaline AA batteries
•Observe correct polarity to
prevent leakage or risk of fire
•Do not mix old and new
batteries
•Do not use re-chargeable
batteries
•Do not use a 9 volt battery
•Remove the batteries if you do
not intend to use the ChickSafe
Eco for a long period.
1
1/8” (3mm)
Raise the sliding door to its fully
open position.
Support the door in that
position.
Once fitted, the ChickSafe will
always open the door to this
height. Make sure it is correct.
4 3/4”
121mm
6 1/2 “ 170mm
Mark two hole positions 4 ¾”
(121mm) apart and approximately
6 ½” (170mm) above the top of the
sliding door.
Make sure they are level and evenly
spaced above the centre of the door.
Make the holes with a 1/8” (3.0mm)
drill bit or bradawl.
CS010 US Issue 01

2
4
5
8
9
10
6
7
3
1/4”
(7mm)
Start to fit the two screws
supplied into the holes you have
made.
Tighten each screw until its head
is 1/4” (7mm) from the surface.
Hang the ChickSafe on the two
screws.
Gently tighten each screw to
make the ChickSafe secure.
Make sure the ChickSafe remains
flat against the fixing surface.
Make a hole or fix a ring to the
centre of the top of the door as
necessary.
Tie the ChickSafe cord to the
hole/ring.
Make sure the cord is taut once
tied on.
Fit the batteries into the holder.
Check the polarity of each
battery!
The battery holder fits this way
up in the top of the ChickSafe.
Fit the connector to the battery
holder.
After 10 seconds the motor will
operate briefly.
Fit the battery cover over the
top.
It pushes down into place.
Check operation carefully for
the first few days to ensure the
installation is successful and the
door is operating smoothly.
The red indicator LED provides
information on current status.
Please continue reading for
more information!
The ChickSafe is now ready!
The door will be opened or
closed according to daylight.
11

3
Darker
Lighter
Single flash every 30 seconds –Door is open
Double flash every 30 seconds –Door is closed
Single flash every 10 seconds –Door is open, replace batteries soon!
Double flash every 10 seconds –Door is closed, replace batteries soon!
Single flash every second –Door is stuck or batteries too discharged to
open the door. Investigate cause!
Cleaning:
Disconnect the battery holder before cleaning the ChickSafe Eco.
Keep the battery holder and electrical connections dry at all times.
Do not immerse the ChickSafe Eco in water.
Wipe surfaces clean with a damp cloth and mild detergent as necessary.
Reset:
If the batteries have been connected before the door is installed, or if the cord has become detached from the door,
it may be necessary to reset the system:
1. The ChickSafe must be upright in its installed position.
2. Disconnect the battery holder connector.
3. Wait 1 minute.
4. Gently pull the end of the cord down and, while pulling, refit the battery holder connector.
5. Maintain tension on the cord. After 10 seconds the cord will be wound out for a second and then start to wind in.
6. Keep maintaining tension on the cord all the time until the motor stops.
7. Disconnect the battery holder.
The system is now reset to the factory position. Follow the installation instructions from the start to ensure the door
opens to the correct position. For helpful information see our ChickSafe ‘Frequently Asked Questions’page at
www.brinsea.com
Closing Light Level Adjustment
Closing light levels at dusk vary with location and direction of
installation. The light level that makes the door close may be
adjusted:
360 degree turn clockwise to decrease light level (darker).
360 degree turn anti-clockwise to increase light level (lighter).
(Use a small, flat precision-screwdriver).
Adjust by one turn at a time. The adjustment range from the
factory setting is approximately 5 turns darker (clockwise), 15 turns
lighter (anti-clockwise). Adjusting further than this range has no
effect.

4
Automatic openers and accessories are intended to help keep chickens safe but the overall responsibility for the welfare
and safety of livestock remains with the owner/keeper. Brinsea, its retailers or distributors will not be responsible for
the loss of livestock or consequential loss in the event of failure however caused.
Product Dimensions:
Height 5.9” (150mm)
Width 5.9” (150mm)
Depth 3.0” (75mm)
Weight 13oz (375g)
Brinsea Products Inc., 704 N Dixie Ave., Titusville, FL 32796-2017 USA.
Phone. [phone] Toll Free 1-888-667-7009 Fax [phone]
e-mail [e-mail], website www.Brinsea.com