3
BriskHeat®Corporation. All rights reserved.
Important Safety Instructions
SAFETY ALERT SYMBOL
The symbol above is used to call your attention to instructions concerning your
personal safety. It points out important safety precautions. It means
“ATTENTION! Become Alert! Your Personal Safety is involved!” Read the
message that follows and be alert to the possibility of personal injury or death.
Immediate hazards which WILL result in severe personal injury or death
Hazards or unsafe practices which COULD result in severe personal injury or
death
Hazards or unsafe practices which COULD result in minor personal injury or
property damage
Programming Your Controller
A person who has not read and understood all operating instructions is not qualified to operate
Do not immerse or spray any component of
the temperature controller in liquid.
Keep volatile or combustible material away
from controller when in use.
Keep sharp metal objects away from
controller.
Failure to observe these warnings may result in
electric shock, risk of fire, and personal injury.
Inspect all components before use.
Do not use controller if any component is
damaged.
Do not repair a damaged or faulty controller.
Do not crush or apply severe physical stress on
any component of system, including cord
assembly.
Unplug controller when not in use.
Failure to observe these warnings may result in personal
injury or damage to the temperature controller.
End User Must Comply to the Following:
Only qualified personnel are allowed to connect electrical wiring
All electrical wiring must follow local electrical codes and NEC Article 427
Final installation/wiring is to be inspected by the authority who has jurisdiction in the area where the heater and
temperature control system are installed
The end-user is responsible for providing a suitable disconnect device
The end-user is responsible for providing a suitable over-protection device. It is highly recommended that a
ground-fault circuit breaker be used
