Bristan Java J BF C User manual

AFTERCARE INSTRUCTIONS
Your fitting has a high quality finish and should be treated with care
to preserve the visible surfaces. All surface finishes will wear if
not cleaned correctly, the only safe way to clean your bath filler is
to wipe with a soft damp cloth. Stains can be removed using
washing up liquid. All bath cleaning powders and liquids will
damage the surface of your fitting even the non-scratch cleaners.
GUARANTEE
All products are manufactured to the highest standards and a 5
year guarantee covers any defect in manufacture. As gold and
special effect finishes are softer than chromium plate, special care
must be taken when cleaning; a 3 year guarantee covers these.
NOTE: The 5 year guarantee on the valves is invalidated if damaged
by any water born debris.
In the interests of continuous product development we reserve the
right to alter specification as necessary.
PRODUCT NAME: J BF C
TELEPHONE HELPLINE: 0844 701 6273
Bristan Group Ltd
Birch Coppice Business Park
Dordon
Tamworth
Staffordshire
B78 1SG
UK
A Masco Company
Web Site: www.bristan.com
Telephone: [phone]
Facsimile: 0844 701 6275
Email: [email protected]
(FI J BF) (Rev. D1) (H)
Java Deck
Mounted Bath Filler
Fitting
Instructions
Please keep these instructions for future reference

CD VALVE
CLEAN WASHER
AND SEAT
WATER PRESSURE
This mixer is suitable for use at all supply pressures. However for
optimum use both the hot and cold supplies should be reasonably
balanced. If the fitting is installed at low pressure (tank fed), then
the minimum height from the outlet of the nozzle to the underside of
the cold tank should be 1.8 metres to ensure adequate
performance.
This mixer should be installed in compliance with Water
Regulations. For further details contact your Local Water Authority.
INSTALLATION
1. Identify all components and check for completeness, particularly
before arranging fitting.
2. Fit the mixer to the bath using the gasket and backnuts.
3. Connect the hot and cold water supplies.
4. Fully open both valves, letting them run for a few minutes to
flush the system.
5. Check all joints and connections for leaks.
6. See over the page for aftercare instructions.
MAINTENANCE
If the fitting begins to drip:
1. Turn off the water supply.
2. Prise off cap, loosen grub screw with 2.5mm hexagon key and
pull off head.
3. Remove valve.
4. Carefully clean seating, rubber washer and ceramic disc.
5. Replace valve and head and turn on the water supply.
6. Contact our helpline if problem persists.
Please note:In the unlikely event you find a part missing please
contact our Customer Service Helpline on 0844 701 6273 or email
[email protected] for immediate dispatch of part.