Britax Steelcraft Sprint User manual

SPRINT
LAYBACK STROLLER
KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE
www.britax.com.au
Series SG1009

ALWAYS FOLLOW THE MANUFACTURERS INSTRUCTIONS.
READ ALL INSTRUCTIONS CAREFULLY BEFORE ASSEMBLY AND USE
OF THIS STROLLER.
THE CORRECT USE AND MAINTENANCE OF THIS PRODUCT IS
ESSENTIAL.
• USE GREAT CARE WHEN USING THE STROLLER ON STAIRS,
ESCALATORS,TRAVELATORS OR OTHER MOVING SURFACES.
• IT IS RECOMMENDED TO REMOVE THE CHILD FROM THE STROLLER
BEFORE GOING UP OR DOWN STAIRS OR ESCALATORS.
• DO NOT LIFT THE STROLLER BY THE ARM BAR (If Supplied)
BECAUSE IT MAY DISENGAGE.
• DO NOT ALLOW CHILDREN TO STAND ON THE SEAT.
• DO NOT HANG BAGS OR GOODS FROM THE HANDLE AS THIS
COULD CAUSE THE STROLLER TO TIP OVER.
• DO NOT LEAVE THE STROLLER AND ITS ACCESSORIES NEAR AN
OPEN FIRE OR EXPOSED FLAME.
• DO NOT PLACE MORE THAN 4 KG IN THE BASKET OR 0.50KG IN
THE CUP HOLDER.
IMPORTANT NOTES:
02
IMPORTANT NOTES

WARNINGS: TO AVOID INJURY OR DEATH:
ALWAYS APPLY THE BRAKES WHENEVER THE STROLLER IS
STATIONARY.
• DO NOT LEAVE CHILDREN UNATTENDED.
• SECURE THE CHILD IN THE HARNESS AT ALL TIMES.
• DO NOT CARRY EXTRA CHILDREN OR BAGS ON THIS STROLLER.
• MAKE SURE CHILDREN ARE CLEAR OF ANY MOVING PARTS IF YOU
ADJUST THE STROLLER.
• DO NOT USE ANY ACCESSORIES OTHER THAN THOSE APPROVED
FOR USE WITH THIS STROLLER BY BRITAX.
• IT IS UNSAFE TO USE ACCESSORIES NOT APPROVED FOR USE WITH
THIS STROLLER.
• THE MAXIMUM WEIGHT OF THE CHILD USING THIS STROLLER IS
NOT TO EXCEED 20 KG.
This CAUTION Symbol is shown at certain steps in
this Instruction Manual to highlight the danger of
being injured by moving parts.
CAUTION
FOR IMPORTANT NOTES AND WARNINGS ON ACCESSORIES - REFER
TO THEIR INDIVIDUAL SECTIONS IN THIS BOOK. THE MAXIMUM
WEIGHT VARIES FOR EACH ACCESSORY.
03
WARNINGS

04
The SMART lifting technique
This technique can be used to pick up small light loads from low levels.
Size up the Load
• Assess the load (size, shape and weight).
• Assess whether the load needs to be moved;
• Where is it going to be placed” Check that there are no obstructions”;
• Assess whether mechanical or human assistance is required.
Move the Load as close to the body as possible
• A load is heavier to lift or carry if it is not close to the body.
• The whole hand should be used to ensure a firm grip.
Always bend your knees
• Maintain balance.
• Keep feet apart and in a comfortable position.
• Minimise lower back bending.
• Bend knees preferable at as large an angle as possible but not at a
right angle - use a semi squat in preference to a full squat.
Raise the load with your legs
• Achieve the lift smoothly and without jerkiness.
• Maintain the normal curvature of the spine to allow the force of the
load to be distributed evenly from the spine to the pelvis.
Turn your feet in the direction that you want to move the load
• Avoid unnecessary bending, twisting and reaching.
• Change direction by turning your feet and not your back.
• To set the load down, squat down, keep your head up and let your legs
do the work.
Remember to ‘THINK TALL’ chest lifted, shoulders relaxed, chin
tucked in and head level.
MANUAL HANDLING TECHNIQUES

CAUTION
05
PLEASE REFER TO PAGE 4 FOR SMART LIFTING TECHNIQUES.
• RELEASE THE STORAGE LATCH WITH DUE CARE AND OPEN THE FRAME.
• WHEN OPENING THE STROLLER, BE AWARE OF THE DANGER OF BEING
INJURED BY MOVING PARTS AND LOCKING DEVICES DURING THE
PROCESS. KEEP ALL HANDS AND LIMBS CLEAR OF THESE PARTS.
• THERE IS POTENTIAL FOR FINGERS OR PARTS OF THE BODY TO BE
INJURED WHEN THE STROLLER IS BEING UNFOLDED, DUE CARE
SHOULD BE EXERCISED.
• KEEP CHILDREN CLEAR OF THE STROLLER WHEN UNFOLDING THE
STROLLER.
• OPEN THE STROLLER SLOWLY AND BE CAREFUL WHERE YOU PLACE
YOUR HANDS. KEEPING YOUR HANDS ON THE HANDLE IS THE BEST
WAY TO UNFOLD THE STROLLER.
OPENING THE STROLLER
AStand the stroller upright. Hold the stroller handle with one hand and
with the other hand release the storage latch.
IMPORTANT NOTES:
ASSEMBLING THE STROLLER

06
OPENING THE STROLLER
BLift the handle upwards until the stroller is fully opened & locked in
position. Push down on the the handle to confirm the frame is locked.
ASSEMBLING THE STROLLER
A Take each swivel wheel and push it down firmly into each of the wheel
mouldings until you hear a ‘click ’ which indicates the wheel has
locked in. Check that each wheel is fully engaged and secured by
pulling against it.
ATTACHING THE SWIVEL WHEELS

07
ASSEMBLING THE STROLLER
A Locate the metal latch underneath the swivel wheel fork and press in to
release & remove the swivel wheel.
REMOVING THE SWIVEL WHEELS
IMPORTANT NOTE: BEFORE ATTACHING THE REAR WHEEL
ASSEMBLY TO THE STROLLER, FASTEN THE BASKET SNAPS TOGETHER
TO SECURE THE BASKET TO THE STROLLER FRAME.
ATTACHING THE REAR WHEEL ASSEMBLY

08
ASSEMBLING THE STROLLER
ATTACHING THE REAR WHEEL ASSEMBLY
A Tip the frame over to install the rear wheel assembly.
CAUTION
B Lower the rear wheel assembly onto the rear legs of the stroller frame
and then push down until the locking pins on the stroller frame are
fastened securely through the holes on the rear wheel assembly. Pull
on the rear wheel assembly to ensure it is correctly installed.

09
ASSEMBLING THE STROLLER
ATTACHING THE REAR WHEEL ASSEMBLY

10
ASSEMBLING THE STROLLER
ASlide the canopy mouldings onto the canopy mounting brackets on
both sides of the stroller frame until they connect together.
BAttach the hook strip on the side of the canopy backflap to the loop
strip on the side of the stroller.
The sun is very strong. DO NOT LEAVE YOUR CHILD EXPOSED TO THE
SUN. The canopy on this product will not give your child total protection
from the harmful rays of the sun.
IMPORTANT NOTE:
ATTACHING THE CANOPY