Brodit 852599 ProClip User manual

23 February, 2020, www.brodit.com, © 2020 Brodit AB
Product 852599
852599 ProClip
Center mount
The ProClip is a mounting bracket for the vehicle’s dashboard. Onto the ProClip you can install e.g. a holder for
your mobile phone or PDA or a handsfree set etc. Safe and convenient -always within easy reach. The ProClip is
car specific and easy to install. The installation is quick, no special tools or dismantle of the dashboard is required
and it will not damage the interior of the vehicle. Made in black ABS plastic. Comes with detailed instructions.
EAN: 7320288525990
Item no 852599 fits:
BMW 3-series M3 E46 98-04 (For Europe)
BMW 3-series M3 E46 99-05 (For USA)
BMW Compact 01-07 (For Europe)

1. 2.
INSTALLATION INSTRUCTIONS
4.3.
Attention! Read all instructions before attaching the ProClip.
1. Press the thin end of the enclosed gap opener into the gap between the air vent frame and the padded
dashboard to widen the gap. Use the enclosed alcohol pad to clean the surface on the dashboard where the
ProClip is to be installed. Peel off the adhesive tape cover on the ProClip.
2. Press/Hook the angled edge on the lower part of the ProClip into the gap between the air vent frame and the
panel above the stereo. Slide the ProClip to the left.
3. Flip the ProClip upwards and press forward on the upper part of the ProClip so it snaps into the gap next to the
gap opener. Note: If the angled edge won't snap into the gap, press down on top of the ProClip until you see or
hear/feel it snaps into place. Pull out the gap opener.
4. The ProClip in place.