Brodit ProClip 852426 User manual

14 February, 2020, www.brodit.com, © 2020 Brodit AB
Product 852426
852426 ProClip
Center mount
The ProClip is a mounting bracket for the vehicle’s dashboard. Onto the ProClip you can install e.g. a holder for
your mobile phone or PDA or a handsfree set etc. Safe and convenient -always within easy reach. The ProClip is
car specific and easy to install. The installation is quick, no special tools or dismantle of the dashboard is required
and it will not damage the interior of the vehicle. Made in black ABS plastic. Comes with detailed instructions.
EAN: 7320288524269
Item no 852426 fits:
Volvo C70 97-05 (For all countries)
Volvo S70 97-00 (For all countries)
Volvo V70 97-00 (For all countries)

1. 2.
INSTALLATION INSTRUCTIONS
4.3.
Attention! Please read all of the instructions and look at the pictures before attaching the ProClip. Note: This
ProClip can be attached within the width of the air vent.
1. Peel off both adhesive tape covers on the ProClip. Choose location for the ProClip within the range of the width
of the air vent. Place the ProClip over the air vent at the selected position. Press the thin end of the two enclosed
gap openers into the gap, one on each side of the ProClip, between the padded part of the dashboard and the
center console panel to widen the gap.
2. Press the thin end of the lower part of the ProClip all the way into the gap between the gap openers. Pull out
the gap openers.
3. Press the grooved edge on the upper part of the ProClip into the gap between the air vent frame and the
padded dashboard. Press until you see or hear/feel it snaps into place. (Note: if the gap is very tight, press the
thin end of the two enclosed gap openers into the gap, one on each side of the ProClip, to widen the gap. Then
press the ProClip into the gap)
4. The ProClip is in place.