Brodit 516042 User manual

25 February, 2014, www.brodit.com, © 2014 Brodit AB
Product 516042
516042 Holder with Pass-Through Connector For a more secure upright and horizontal position. Adjustable
holder, fits devices with skins.
This is the choice for you who are using your iPhone with navigation and easily want to switch between an upright
position and a horizontal position - simply turn the holder into desired position. When installing, place the holder
in the desired position (upright/horizontal) that you will be using as standard. The holder is adjustable and fits
devices with skins. The holder provides a more secure upright and horizontal position than a standard holder.
The holder is equipped with a pass-through connector. This means that all cables that can be used with the
iPhone can also be used with the holder, for example a charging cable or an interface cable. When you have
attached the cable to the holder it is firmly in place and you do not have connect it manually to the device each
time you put the iPhone in the holder. You can run the cable through the back part of the holder for a cleaner
look. (Cable not included)
The holder is attached to a tilt swivel, this means you can adjust the angle of the device in order to avoid light
reflection on the screen. Attach onto ProClip Mounting Platform.
EAN: 7320285160422
Item no 516042 fits:
Apple iPhone 3G (For all countries)
Apple iPhone 3GS (For all countries)
1(2)

1. 2.
INSTALLATION INSTRUCTIONS
4.3.
Please read all of the instructions and look at the pictures before attaching the holder.
1. To adjust the holder to your unit: Loosen the screws on the back side of the holder, so the sides of the holders
can be adjusted. Place the unit in the holder and press the sides together so the unit is firmly in place. Screw on
the screws on the back side of the holder.
2.To install the holder. Loosen the screw in the center of the holder so you can remove the tilt swivel attaching
plate on the back. Place the attaching plate on desired position. Screw the attaching plate into place with the
enclosed screws. Place the holder over the attaching plate so the tilt swivel fits. Screw the holder onto the
attaching plate. You can easily switch between an upright and a horizontal position, simply by turning the holder
into desired position.
3. To place the device in the holder: Place the bottom part of the device into the holder. Press the top of the
device forward and in the same time slide the device downward into place in the holder.To remove the device
from the holder: Press the upper part of the holder forward. When the device is set free, lift it upward out of the
holder.If you are using a cable to your device: Press the cable into place in the cable holder in the bottom part of
the holder. The cable will then be held in place giving a neat installation.
4. The holder is in place.
2(2)