Brodit 713184 User manual

10 June, 2020, www.brodit.com, © 2020 Brodit AB
Product 713184
713184 Active holder for fixed installation Slim design with charger integrated in the holder. For use with Li-Ion
batteries. With Easy-switching system.
Are you using a two-way radio every day in your work? Then a Brodit active holder will make your days much
easier! By keeping the device in an active holder, you will always have it within easy sight and reach while driving
between jobs. The cables are to be connected inside the dashboard, this gives a discreet, neat installation
without cables hanging over the interior.
Easy-switching system:
The easy-switching system enables you to upgrade the holder only, and keep the installed cables. It saves you a
lot of time! When upgrading to a new device, you do not longer need to make a full installation. Same goes for
maintenance in case of warranty or damage. You simply disconnect the holder from the charging cable via the
Molex 6-pin quick connector, and then connect the new holder. The switch is done in a few seconds.
The charging device is integrated in the holder itself, so there is no large charging box on the cable and LED
indicator to show that charging is in progress, the indicator changes from red to green when fully charged. 12/24
Volt. The product is E-approved. Connect the power cable with a 2 A fuse. 2 A charger. Professional installation
recommended. Attach onto ProClip Mounting Platform.
EAN: 7320287131840
NEW!
Item no 713184 fits:
AnyTone AT-D878UV (For all countries)

1. 2.
INSTALLATION INSTRUCTIONS
4.3.
Please read all of the instructions and look at the pictures before attaching the mount.
1. Attach the mount: Place the mount into the desired position.
2. Attach the mount with the enclosed screws.
3. The mount is in place.
4. The mount is in place.