Brodit 213549 User manual

25 May, 2020, www.brodit.com, © 2020 Brodit AB
Product 213549
213549 Heavy Duty ProClip
Center mount ,High strenth mounting platform
Extra strength mounting platform for installation of heavier devices. You can keep your device in a holder or
attach it directly onto the mounting platform. The placement is optimized for touch screens, PDAs, taximeter
screens and printers. You will have your device within easy reach, safe and convenient! The installation is quick
and easy and will not damage the interior. Detailed installation instructions included.
EAN: 7320282135492
Item no 213549 fits:
Opel Insignia B 18-20 (For Europe)

1. 2.
INSTALLATION INSTRUCTIONS
4.3.
Please read the instructions and look at the pictures carefully before installing.
This mounting bracket consists of three parts:
Part 1: Mounting plate (the largest part)
Part 2: Short support arm
Part 3: Long support arm
1. Place Part 2 under the left end of Part 1 and press it into place. Press the cog wheel into place on the
underside. Press the lock nut into place on the top, so the teeth fit in the cog wheel. Put the screw into place and
fasten it without tightening. Place Part 3 under the right end of Part 1 and press it into place. Press the cog wheel
into place on the underside. Press the lock nut into place on the top, so the teeth fit in the cog wheel. Put the
screw into place and fasten it without tightening. Pull out the support arms to maximum length.
2. Press the thin end of the enclosed gap opener into the gap between the air vent and the dashboard to widen
the gap on top of the dashboard. Hook the angled lower parts of Part 1 under the dashboard overhang. Press the
angled edge of Part 2 and Part 3 into the gap next to the gap opener so the support arms are resting on the
dashboard. Press the support arms into Part 1 so they get shorter and the mount is in held in place. Pull out the
gap opener.
3. Lock the mount into place by carefully tightening the lock screws alternately. It is important not to tighten the
screws too hard. When the mount is firmly in place, lock the position with the enclosed Allen key.
4. The product is in place.