Brodit ProClip 853804 User manual

9 September, 2013, www.brodit.com, © 2013 Brodit AB
Product 853804
853804 ProClip
Center mount
The ProClip is a mounting bracket for the vehicle’s dashboard. Onto the ProClip you can install e.g. a holder for
your mobile phone or PDA or a handsfree set etc. Safe and convenient -always within easy reach. The ProClip is
car specific and easy to install. The installation is quick, no special tools or dismantle of the dashboard is required
and it will not damage the interior of the vehicle. Made in black ABS plastic. Comes with detailed instructions.
Fits models with a compartment on top of the dash and models with a speaker on top of the dash.
EAN: 7320288538044
Item no 853804 fits:
Hyundai Santa Fe 06-12 (For Europe)
1(2)

1. 2.
INSTALLATION INSTRUCTIONS
4.3.
Please read all of the instructions and look at the pictures before attaching the ProClip. Peel off the cover of the
adhesive tape on the ProClip.
1. Compartment Dash: Press the thin end of the enclosed gap opener into the gap between the panel
surrounding the clock and the stereo panel frame, to widen the gap. Open the compartment door on top of the
dashboard.
1. Speaker Dash: Press the thin end of the enclosed gap opener into the gap between the panel surrounding the
clock and the speaker panel, to widen the gap.
2. Compartment Dash: Press the angled edge on the lower part of the ProClip into the gap next to the gap
opener.
2. Speaker Dash: Press the angled edge on the lower part of the ProClip into the gap between the stereo and the
panel frame surrounding the clock. Note: the stereo screen will still open and close freely.
3. Compartment Dash: Press firmly forward on the upper part of the ProClip so the angled edge hooks over the
compartment edge. Press until you see or hear/feel it click into place. Pull out the gap opener. Close the
compartment door.
3. Speaker Dash: Press firmly forward on the upper part of the ProClip so the angled edge goes into the gap next
to the gap opener. Press down on top of the ProClip to make sure the angled edge is all the way down in the gap
and for best possible attachment of the adhesive tape. Pull out the gap opener.
4. The ProClip is in place.
2(2)