Tools needed: #2 & #3 Phillips head screwdrivers and a 1/2” (13mm) socket or wrench.
IMPORTANT! Start all screws BY HAND when assembling your shear. This will help avoid cross-threading.
1. AT TACH R AILS 2. AT TACH TAIL
Quick Start Guide
for EZ Shear Models #120, #126
3. AT TACH TABLE
A. Attach front of table to base, using Item D screws.
Tighten with #3 Phillips.
B. Attach back of table to tail using Item E screws.
Tighten with #2 Phillips.
4. AT TACH HANDLE
Insert handle into slot. Insert Item F screws
and tighten with 1/2” (13mm) wrench.
5. ATTACH FENCE
Align fence with one of two hole sets on the table: at 90° or at 45°.
Use Item C screws with Item G wingnuts to fasten securely.
5
Item C
Item G
Item E
A. (4) #14 x 3” PH Phillips Self-Tapping Screws
B. (6) M6 x 25mm PH Phillips Machine Screws
C. (5) M6 x 16mm FH Phillips Machine Screws
1. Power Assembly
1a. Safety Lock pin
2. Handle Assembly
3. Fence
4. Table The Hardware Kit is used in multiple models. Your Shear may not use all of the items listed.
5. Tail
6. Rails x 2
7. Hone Stone
8. Hardware Kit
D. (4) #10 x 1 FH Phillips Self Tapping Screws
E. (2) M8 x 50mm Hex Bolts
F. (2) M6 Wing Nuts
In the Box: In the Hardware Kit:
2
1
Item F
4
Tail
Power Assembly
Item D
3B
3A
Attach rails to Power Assembly base using
Item A screws.
Attach tail to rails using Item C screws.
Make sure holes in tail are facing up.
ASSEMBLING YOUR SHEAR
