BWI Eagle AIR-EAGLE XLT PLUS Manual

PRODUCT INFORMATION
BULLETIN
105 Bonnie Drive
Butler, PA 16002
724-283-4681
724-283-5939 (fax)
www.bwieagle.com
AIR-EAGLE®XLT PLUS
900MHz RF Receiver
MODEL 461-21600-DC
DESCRIPTION
The AIR-EAGLE XLTPLUS is an RF system designed for long range
wireless remote control of electricalapparatus in avariety of industrial
applications. Systems can consist of any numberof transmitters and
receivers working together. This receiver is equipped with 16 independent
relays thatcan switch 5 amps @ 120VAC or 30VDC andcan be directly
interfaced with the customer's equipment or P.L.C. Eight user selectable
frequencies allowmultiple systems to be usedin the same area. The Air-
Eagle XLT Plus can receive remotesignals transmitted from up to 5000
feet away (with a handheld transmitter) or up to 10 miles away (with a
stationary transmitter and external antennas).
SERIES FEATURE
The “461” series features built-in repeating capability. Each receiver
accepts and performs commands from the transmitterthen repeatsthe
commands to any other receiver within its range. When using multiple
receivers this increases range and reliability because if there is a receiver
that the transmitter can’t quite reach but is within range of another receiver
that HAS gotten the signal, it will still get its command from that receiver.
APPROVALS
United States (FCC)
MCQ-XBPSX
Canada (IC)
1846A-XBPSX
INSTALLATION
DISCONNECT DC Power from all equipment before installation.
1. Mount the AIR-EAGLE XLT PLUS RECEIVER in a convenient location.
2. Install relay wiring to terminal strip.
3. Install antenna onto antenna connector located on the right side on
the enclosure.
4. Connect supplied power input cable to your external power source.
(AC Model Pictured)
TERMINAL STRIP WIRING
BOTTOM BOARD
1
N/O Relay #1
10
N/O Relay #4
19
N/O Relay #7
2
C Relay #1
11
C Relay #4
20
C Relay #7
3
N/C Relay #1
12
N/C Relay #4
21
N/C Relay #7
4
N/O Relay #2
13
N/O Relay #5
22
N/O Relay #8
5
C Relay #2
14
C Relay #5
23
C Relay #8
6
N/C Relay #2
15
N/C Relay #5
24
N/C Relay #8
7
N/O Relay #3
16
N/O Relay #6
8
C Relay #3
17
C Relay #6
9
N/C Relay #3
18
N/C Relay #6
TOP BOARD
1
N/O Relay #9
10
N/O Relay #12
19
N/O Relay #15
2
C Relay #9
11
C Relay #12
20
C Relay #15
3
N/C Relay#9
12
N/C Relay #12
21
N/C Relay #15
4
N/O Relay #10
13
N/O Relay #13
22
N/O Relay #16
5
C Relay #10
14
C Relay #13
23
C Relay #16
6
N/C Relay #10
15
N/C Relay #13
24
N/C Relay #16
7
N/O Relay #11
16
N/O Relay #14
8
C Relay #11
17
C Relay #14
9
N/C Relay #11
18
N/C Relay #14
DC INPUT
Terminal #1
Negative (-) 9-36VDC INPUT
Terminal #2
Positive (+) 9-36VDC INPUT

AIR-EAGLE®XLT PLUS
900MHz RF Receiver
MODEL 461-21600-DC
GENERAL OPERATION
Relays #1 thru #16 energize or de-energize based on specific
commands from a handheld or contact input transmitter.
BUTTON OR
INPUT
ACTIVATED
RELAY OPERATION
"1"
Relay #1 energizes,maintained momentary
"2"
Relay #2 energizes, maintained momentary
"3"
Relay #3 energizes, maintained momentary
"4"
Relay #4 energizes, maintained momentary
“5”
Relay #5 energizes, maintained momentary
“6”
Relay #6 energizes, maintained momentary
“7”
Relay #7 energizes, maintained momentary
“8”
Relay #8 energizes, maintained momentary
"9"
Relay #9 energizes,maintained momentary
"10"
Relay #10 energizes, maintained momentary
11"
Relay #11 energizes, maintained momentary
"12"
Relay #12 energizes, maintained momentary
“13”
Relay #13 energizes, maintained momentary
“14”
Relay #14 energizes, maintained momentary
“15”
Relay #15 energizes, maintained momentary
“16”
Relay #16 energizes, maintained momentary
DIMENSIONS
RELAY & FREQUENCY SET-UP
This unit is shipped from the factory with SEL1 switches #1 and #2 in the
open positions.All sixteen relays will operate in a maintainedmomentary
manor, and unit is receiving commands onfrequency one. If you wish to
change these default settings, follow the instructions onthe table below.
1) Remove power from unit
2) Remove top cover.
3) Select desired relay operation and/or network frequency using table
below.
4) Reattach cover and apply power.
5) Programming is now complete.
RELAY CONFIGURATION
SEL1
SWITCH
NUMBER
OPEN
CLOSED
SW1
Relays #1 thru #8 maintained
momentary (default)
Relays #1 thru #8
toggle/latch
SW2
Relays #9 thru #16 maintained
momentary (default)
Relays #9 thru #16
toggle/latch
Maintained Momentary –Relay mimics button or input –when
depressed or closed, relay will be energized; when released, relay de-
energizes
Toggle Latch –Relay changes (and holds) its state each time the
corresponding button or input is depressed or closed.
SW3
Vibrating Feedback OFF
(default)
Vibrating Feedback ON
SW4
Not used on this model
FREQUENCY SET-UP
SEL1
(SW5-7)
Network
Frequency
SW5
SW6
SW7
1 (default)
OPEN
OPEN
OPEN
2
CLOSED
OPEN
OPEN
3
OPEN
CLOSED
OPEN
4
CLOSED
CLOSED
OPEN
5
OPEN
OPEN
CLOSED
6
CLOSED
OPEN
CLOSED
7
OPEN
CLOSED
CLOSED
8
CLOSED
CLOSED
CLOSED
SPECIFICATIONS
DC Input
9 - 36 VDC, 8 W
Fuse Protected
2 amp
Relay Contacts
SPDT 5 amp @120VAC or 30VDCper
channel
Receiver Range
Up to 1 Mile with Rubber Duck Antenna / Up
to 10 Miles with External Antenna
Note: Maxrange figures are estimates,based on free-air terrain with limited sourcesof
interference. Actual range will vary based on transmitting power, orientation of transmitter and
receiver, height of transmitting antenna, height of receiving antenna, weather conditions,
interference sources in the area, and terrain between receiver and transmitter, including, but not
limited to, indoor and outdoor structures such as walls, metal objects, trees, buildings, hills, and
mountains
Receiver Frequency
900 MHz Spread Spectrum
RF Networks
Eight Independent Network Frequencies
Enclosure
Hinged fiberglass with window / NEMA 3,
3R, 4, 12, 13
Operating Temp
-40oF to +185oF

AIR-EAGLE®XLT PLUS
900MHz RF Receiver
MODEL 461-21600-DC
ACCESSORIES
Standard Antenna (Included):
900MHz TNC “Rubber Duck” Antenna
49-1103
Mobile/Base Antennas –
Used to help achieve max range in both nonline of sight andline of
sight applications. - Contact BWI Eagle for recommendations
900MHz Thru-Hole Mount Mobile Antenna
49-2101
900MHz Magnet Mount Mobile Antenna
49-2102
900MHz Omni Directional Base Antenna
49-3101
900MHz Yagi Directional Base Antenna
49-3102
High Quality Coax Cables –
Used to connect external high gain antennas to control unit
Flex Coax Cable w/Connectors –Available in
5’,15’,25’,30’,40’,60’,80’,100’ Lengths
49-4000-XX
(XX = # of Feet)
Bulkhead Extensions –
Used to provide an external antenna connection when mounting
control unit inside another enclosure
TNC Male to TNCBulkhead CableAssembly
- Available in 2’, 4’, 7’ Lengths
49-5004-X-ISO
(X = # of Feet)
LIMITED WARRANTY STATEMENT
BWI Eagle Inc. warrants the Air-Eagle XLT Remote Control System, if
properly used and installed, will be free from defects in material and
workmanship for a period of 1 year after date of purchase. Said warranty
to include the repair or replacement of defective equipment. This
warranty does not cover damage due to external causes, including
accident, problems with electrical power, usage not in accordance with
product instructions, misuse, neglect, alteration, repair, improper
installation, or improper testing. This limited warranty, and any implied
warranties that may exist understate law, apply onlyto the original
purchaser of the equipment, and last only for as long assuch purchaser
continues to own the equipment. This warranty replaces all other
warranties, express orimpliedincluding, but not limited to, the implied
warranties or merchantability and fitness for a particular purpose. BWI
Eagle makes no express warranties beyondthose stated here. BWI
disclaims without limitation, implied warranties of merchantability and
fitness for a particular purpose. Some jurisdictions do not allowthe
exclusion of implied warranties so this limitation may not apply toyou. To
obtain warranty service, contact BWI Eaglefor a return material
authorization. When returning equipment toBWI Eagle, the customer
assumes the risk of damage or loss duringshipping andis responsiblefor
the shipping costs incurred.
DOCUMENT DATE: 07/22/2021 / PRODUCT REV. 3
105 Bonnie Drive
Butler, PA 16002
[phone]
Fax [phone]
www.bwieagle.com