CADO LEAF 320i User manual

120
Air Purifier
320i
Instruction Manual
취급설명서
使用說明書
AP-C320i

ENGLISH ....................................................... 2
Make sure you read this document, as well as the attached "Safety Precautions",
before using the appliance. Please keep these documents after reading.
한국어 .......................................................... 26
사용하기 전에 반드시 이책자 및' 안전 주의사항 ' ( 별책 ) 을읽어 주십시오 .
이책자는 다읽고 난후에도 잘보관하십시오 .
繁體中文 ...................................................... 50
使用前請務必閱讀本書及另一本「安全上的注意事項」。
閱畢後，也請妥善保管。
1

Instruction Manual

3
EN
Table of Contents
Overview.................................................. 4
Assembly of base unit............................ 5
Installing a lter ....................................... 5
Connecting power ................................... 7
Notes on Installation .............................. 8
Operating Instructions........................... 9
Control panel........................................... 9
Starting operation.................................... 9
Changing operation mode .................... 10
Manual mode......................................... 11
Timer operation ..................................... 11
Photocatalytic lamp ............................... 12
Dimmer function.................................... 12
Light-off function ................................... 12
Odor & dust monitor ............................. 13
Notes on odor sensor and
dust sensor............................................. 13
Cleaning Procedure..............................14
Base unit ................................................ 14
Cleaning of lter .................................... 16
Filter replacement notice....................... 16
Filter replacing method ......................... 17
Information on lter............................... 18
Initialization of Filter Replacement
indicator................................................. 19
Troubleshooting....................................20
Specifications ........................................24

Overview
This product does not eliminate all harmful substances in the air
(for instance the product is not capable of removing carbon monoxide that is contained in
cigarette smoke).
This product does not ventilate a room either. Periodically ventilate the room when using the
product in a closed room.
4EN
Illumination intensity
sensor
Control panel
Air inlet
Power cord
Photocatalytic
lamp
(Inside)
Odor & dust
monitor
Air outlet
Handle
Sensor cover
Filter cover
Cover switch
Filter
Odor sensor
/ dust sensor
(Inside)

Assembly of base unit
Installing a filter
1. Slide down the cover switch located on the
rear side of the base unit and remove the
lter cover.
2. Take out the lter from the plastic bag.
• Always turn the power of the base unit OFF when installing a lter.
• Take the lter out of the plastic bag when installing a new lter.
5
EN

3. Cut open the plastic bag containing the
lter and take out the lter.
4. Face the ribbons outward and insert
the lter deep into the base unit to
set.
Ribbons
5. Close the lter cover.
Fit the cover onto the base unit while the
cover switch is still slided down.
The product cannot start operating if
the lter cover is not properly installed
(Power indicator ashes slowly).
6EN

Connecting power
1. Connect the power cord to the power cord
connecting port.
Power cord
connecting port
2. Insert the power plug into the power
outlet.
All indicators as well as the odor & dust
monitor ash for about 2 seconds when
the power is connected normally.
7
EN

8EN
Notes on Installation
In order to ensure that the air circulates well, do not place any objects around the base unit
and secure a space of at least 30 cm.
Do not use the product on carpets or rugs
with long piles. The unit may tilt or air inlet
may be blocked by dust or the like and cause
malfunction.
Do not use the product at a location on an
incline, unstable location or high location. Such
locations present risk of falling, bumbling or
malfunction.
No! No!

9
EN
Operating Instructions
Control panel
Power indicator
Operation
mode indicator
Air volume
indicator
Illumination
intensity sensor
Timer
indicator
Power button
Mode button
Air Volume button
Timer button
Light-off button
Filter replacement indicator
(red) / Wi-Fi indicator (green)
* Available with models that
feature Wi-Fi function only.
Starting operation
Push the Power button.
The indicator turns on and the product starts to operate in the Auto mode .
The indicator turns off and the product stops operating when the Power button is pressed while the
product is in operation.