Canvas 088-0342-8 User manual

HAVANA GAZEBO
MODEL NO. 088-0342-8
ASSEMBLY INSTRUCTIONS
Toll-free: 1-888-670-6684
IMPORTANT: Please read this manual carefully before beginning assembly of this product.
Keep this manual for future reference.

3
TABLE OF CONTENTSIMPORTANT SAFETY INSTRUCTIONS
IMPORTED BY TRILEAF DISTRIBUTION TRIFEUIL TORONTO, CANADA M4S 2B8
Table of contents 3 Important safety instructions 3 Parts list 4 Assembly 5 Cleaning and maintenance 12 Specifications 12 Warranty 13
IMPORANT: Retain for future reference, and ready carefully.
Warning! To reduce the risk of serious injury, read the following safety
instructions before assembling and using the gazebo.
Caution! Always keep children under close supervision while they are near this
product. Keep pets away while setting up the gazebo. Caution! Check municipal by-laws prior to installing the gazebo.
~This product is intended for domestic outdoor use i.e. decorative and sunshade purposes only.
~Always place and assemble the gazebo on flat horizontal ground.
~Consult with your local governing authority / local municipal codes regarding installation of temporary
structures before assembly.
~Ensure there is enough clearance around the product. Before assembling the gazebo, make sure to leave
a distance of not less than 6’ (1.8 m) from any structures or obstructions, such as fences, garages, houses,
overhanging branches, laundry lines, or electrical wires.
~Anchor the gazebo to the ground with stakes for added safety. Stakes are provided to secure the gazebo to the
ground. If you wish to secure the gazebo to a concrete and wood surfaces, use anchors suited for these surfaces
(anchors not included).Do not assemble the gazebo on sandy, muddy or loose soil, as stakes are not strong enough
~If more than one gazebo is set up, keep a minimum distance of 10’ (3 m) between the gazebos.
~Any assembly or maintenance of the gazebo must be carried out by adults only.
~
~Some parts may contain sharp edges. Wear protective gloves if necessary. ~Check all nuts and bolts periodically for tightness. If required, tighten them.
~Repairing and replacing parts should be done by a qualified technician.
~Always disassemble the gazebo before experiencing heavy wind conditions, as it is not designed to withstand
harsh weather, including high wind, rain, and snow. In these conditions it might tip over and could cause injury to
bystanders.
~Always ensure that the canvas is taut to avoid water accumulation on the roof. If water accumulates on the roof,
remove it immediately or disassemble the gazebo in order to avoid damage.
~Do not light any fires inside or near the gazebo.
~Do not panic if fire breaks out inside the gazebo. Leave by the nearest exit. Call the fire department. Do not return
to the gazebo until the fire fighters allow you to do so.
~Do not hang any weights on the roof frame. ~Do not climb onto the roof of the gazebo. Doing so may cause the gazebo to fall down, possibly resulting in serious
injury.
~If the gazebo will not be used for a long period of time (e.g. during winter time), disassemble and store it in a clean,
dry environment.
~Retain the original packaging to store the gazebo.
MADE IN CHINA
to anchor in these types of soil.
A
nchor the gazebo to the ground with stakes for added safet
y
. Stakes are provided to secure the gazebo to the
g
round. I
f
you wish to secure the gazebo to a concrete and wood sur
f
aces, use anchors suited
f
or these sur
f
aces
(anchors not included).

4 5
MODEL NO. 088-0342-8
ASSEMBLY
PART LIST
Left frame
-
4
Right frame
-
4
Pole - 4 Lower roof top connector - 1 Hook - 1
M6 x 20 Bolt - 28+ 2 spare
Short bar - 4
M6 Flat washer - 40+ 2 spare M6x40 Screw -
Medium bar - 4
M6 Nut - 12+ 1 spare
Long bar - 4
Wrench - 1
Lower roof canopy - 1
Stake - 12
Touch-up paint - 1
Upper roof top connector - 1
Top pole - 4 Top roof canopy - 1
Mosquito net - 1 Plastic ring - 40
1A
1B
1C
2A
2B
AA
2C
BB
CC
2D
DD
2E
W
W
3A
GG
HH
3B
3C
3D
3E
3E1
Let us help you! DO NOT RETURN YOUR PRODUCT TO THE STORE. CALL US FIRST! 1-888-670-6684 If you have questions regarding your product, require warranty assistance, or have damaged or missing parts, please call our customer
service toll-free helpline. Contact us for assistance; we’re here to help.
CAUTION!
~Proper placement of the gazebo is essential. Do not place the product
underneath electrical lines.
~Keep children under close supervision while they are playing around this
product. This product contains small parts which can be swallowed by
children.
~Keep fingers away from places where they can be pinched or trapped. ~Do not attempt to assemble the gazebo if any part is missing.
IMPORTANT: Please read and understand this manual before any assembly. Before beginning
assembly of the product, make sure all parts are present. Compare parts with packaging
contents list. If any part is missing, or if you have any questions, contact the service centre at
1-888-670-6684 (toll-free). Take all parts from the packaging box and position them on a clean floor. Remove all packing
materials and place them back into the box. Do not dispose of the packing materials until
assembly is complete. Read each step carefully before beginning any assembly and make sure
you understand each step.
Needed for assembly:
2 People Screwdriver
Ladder Hammer
12+ 2 spare
+ 2 spare
+ 2 spare
+ 2 spare
e
+ 1 spare

76 7
MODEL NO. 088-0342-8
ASSEMBLY
ASSEMBLY
Step 1 Requires 1A, 1B, AA, BB
Step 3 Requires 1C, GG
Anchor the pole (1C) to the ground using stakes (GG). Repeat this step for every pole until all four poles are anchored.
Step 2 Requires 1A, 1B, 1C, AA, BB
Step 4 Requires 2A, 2C, 2D, 2E
AA
AA
GG
BB
BB
Note: When using screws and nuts to assemble the product, always use a flat washer between the frame and the screw and/or nut. This will protect the parts from wear and tear.
Connect the left frame (1A) to the right frame (1B) on the upper and lower sides using M6 x 20 bolts (AA) and M6 flat washers (BB).
Align the holes of the assembled frames (1A, 1B) with the holes of the poles (1C). Secure the frames with the poles using four M6 x 20 screws (AA) and four M6 flat washers (BB).
Connect the four short bars (2C) to the four medium bars (2D). Insert the
other end of the short bars (2C), as well as the long bars (2E), into the lower
roof top connector (2A), alternating the bars as shown in the illustration.
1A 1B
1C
AA
GG
1C
AA
BB
2C
2D
2C
2E 2C
2E
2E
2C
2E 2C
2A
1A 1B

98 9
MODEL NO. 088-0342-8
ASSEMBLY
ASSEMBLY
Step 6 Requires 2D, 2E, BB, CC, DD Attach the other end of the medium bars (2D) to the supports on the corners
of the assembled frame with one M6 x 40 screw (CC), one M6 flat washer (BB), and one M6 nut (DD) for each corner of the gazebo frame. Likewise, fasten the other end of the long bars (2E) to the supports on the
sides of the assembled frame with one M6x40 screw (CC), one M6 flat
washer (BB), and one M6 nut (DD) for each side of the gazebo frame.
Step 8 Requires 3B, 3C, BB, CC, DD Insert the top poles (3C) into the upper roof top connector (3B). Secure them onto the corners of the lower roof assembly using an M6 x 40 screw (CC), an
M6 flat washer (BB), and an M6 nut (DD).
BB CC DD
2E
2D
DD
3C
3B
BB C
C
DD
Step 7 Requires 3A Place the lower roof canopy (3A) on top of the roof frame. Note: Do not unfold the canopy completely in this step in order to assemble
the top roof.
3A
Step 5 Requires 2B
Insert and screw the hook (2B) tightly at the centre of the lower roof top
connector.
2B

1110 11
MODEL NO. 088-0342-8
ASSEMBLY
ASSEMBLY
Step 10 Requires 3A Step 12
Step 11 Requires 3E, 3E1
Unfold the lower roof canopy (3A) and fit it to the four corners of the gazebo
frame.
Hang the mosquito net (3E) onto the outer tube around the assembled frame
using the plastic rings (3E1).
Note: Use the inner tube for hanging privacy panels (sold separately).
The gazebo is ready for use.
3E1
3E
3A
Step 9 Requires 3D Fit the top roof canopy (3D) onto the top roof assembly.
3D

12 13
MODEL NO. 088-0342-8
CLEANING AND MAINTENANCESPECIFICATIONS
WARRANTY
This CANVAS™product carries a one (1) year warranty against defects in
workmanship and materials. Trileaf Distribution agrees to replace the defective product free of charge within the stated warranty period, when returned by the original purchaser with proof of purchase. This product is not guaranteed against wear or breakage due to misuse and/or abuse.
• For washing the fabric parts:
- Spread the fabric and use a soft bristle brush to clean. - Do not use detergent. - Water should be cold to lukewarm, never more than 25°C (77°F). - Air dry only. Do not spin in washing machine or hand squeeze.
• Do not use bleach, acid, or other abrasive cleaners on the canopies or frame parts. • Steel components of garden accessories and furniture are coated with rust inhibiting
paint. However, due to the nature of steel, surface oxidation (rusting) will occur if this protective coating is scratched. This is a natural process. To minimize this condition, it is recommended that care be taken when assembling and handling the product, in order to prevent the paint from being scratched. If scratching or damage occurs, it is recommended to coat that area immediately with rust-inhibiting paint (included). Surface rust can be removed easily by applying a little common cooking oil. If surface oxidation (rusting) occurs and no measures are taken to correct it, the oxidation may start dripping onto the assembly surface, which may cause rough stains that could be dicult to remove.
CAUTION!
• Check all screws and nuts periodically for tightness. If required, tighten
them.
• Disassemble the gazebo in the reverse order of the assembly steps.
Always disassemble the gazebo completely. A partially disassembled gazebo is not stable enough to resist wind and bad weather, and therefore can be damaged and/or cause damage.
Dimensions (L x W x H) 10 x 10 x 9’ 10”
3 x 3 x 2.9 m
Product weight 126 lb
57 kg