caron 7000-25 User manual

MODEL 7000-25
INST-PM-7000-25

Revision Log
Revisions
Description
Letter
Date
A
10-11-2016
Initial release.
B
04-02-2018
New cover.

INST-PM-7000-25 Rev B 04/02/2018
Parts Required: (1) Air Filter, (2) Atomizers
Tools Required: Ladder, Flatblade Screwdriver, Phillips Screwdriver, (2) 8″
Crescent Wrenches
Parts included in Preventative Maintenance Kit for Model 7000-25 are shown below.
Note: Photos may have a different appearance depending on chamber options.
1. Remove air filter cover using flatblade screwdriver as shown below. Note:
Remove air filter cover by turning screw no more than ¼ turn.
INSTRUCTIONS FOR REPLACING AIR FILTER AND ATOMIZERS IN
MODEL 7000-25
REPLACING AIR FILTER
Air Filter Cover
Air Filter
Atomizers

INST-PM-7000-25 Rev B 04/02/2018
2. Remove air filter and discard as shown below.
3. Install new air filter with cardboard side towards chamber as shown below.
4. Reinstall air filter cover using flatblade screwdriver. Note: Fasten air filter cover
by turning screw no more than ¼ turn.
Air Filter
Air Filter with Cardboard towards Chamber

INST-PM-7000-25 Rev B 04/02/2018
Note: Photos may have a different appearance depending on chamber options.
1. Turn off chamber and unplug power cord.
2. Remove shelves from chamber.
3. Remove shelf channels located near top of chamber if necessary.
4. Remove false floor from chamber by pulling access port upwards while bending
edges downward as shown below.
5. Remove (4) screws securing intake diffuser using Phillips screwdriver bit as shown
below. Note: Retain screws.
6. Remove intake diffuser by pulling towards front of chamber.
REPLACING ATOMIZERS
Disconnect electrical power before removing interior parts.
Intake Diffuser Mounting Screws (as viewed from inside chamber under intake diffuser)
Intake Diffuser
False Floor Access Port

INST-PM-7000-25 Rev B 04/02/2018
7. Remove (2) screws securing drip pan using Phillips screwdriver bit as shown
below. Note: Retain screws.
8. Pull drip pan downward as shown below. Note: If necessary use flatblade
screwdriver to pry drip pan down as shown below.
9. Remove and discard old atomizers using (2) 8″crescent wrenches as shown below.
10.Install new atomizers.
11.Reinstall drip pan. Note: If necessary use flatblade screwdriver to install drip pan.
12.Secure drip pan with retained (2) screws using Phillips screwdriver bit.
13.Align tabs on intake diffuser with drip pan.
Drip Pan Mounting Screws
Drip Pan
Drip Pan
Atomizer
Atomizers

INST-PM-7000-25 Rev B 04/02/2018
14.Secure intake diffuser with retained (4) screws using Phillips screwdriver bit.
15.Reinstall false floor.
16.Reinstall shelf channels.
17.Reinstall shelves.
18.Continue to instructions for replacing additional accessory preventative
maintenance items if applicable or plug in power cord and turn on chamber.
19.Reset air filter and atomizer alerts by pressing Settings button on right side of
Home screen as shown below.
20.Press Maint. button as shown below.
Settings Button
Maint. Button

INST-PM-7000-25 Rev B 04/02/2018
21.Press Reset buttons for Replace air filter and Replace atomizers as shown below.
22.Press Home button as shown below.
Reset Button
Home Button