Case Pala 108199 User manual

Pala
Dressing Table
Care Instructions
Case Furniture Ltd
London, SW18 2HZ
United Kingdom
[email protected]
casefurniture.com
Pala Dressing Table – designed by Sarah + Henrik Böttger.
To prolong the life of the product and retain its appearance and functionality,
we would like to give you some relevant information and care advice:-
This product is manufactured using solid and veneered European oak.
European craftsmen manufacture this product and there is variety between each unit.
Wood is a natural product so colour and grain variations are inevitable.
Natural Timber is affected by sunlight; this can cause the wood colour to darken. For this
reason (especially if placed in direct sunlight) it is recommended that placing objects for
long periods in the same position is avoided. This colour adjustment becomes less
relevant as the product ages.
It is recommended that no abrasive cleaners or solvents are used to clean the unit, please
only use proprietary furniture polishes or warm water with diluted detergent.
We thank you for purchasing this product and wish you many years of enjoyable and
functional use.
For more related products please visit: casefurniture.com

1. Unpack all components and allow
ample room for assembly and turning.
Please remove the two top covers from
the dressing table before proceeding.
2. Insert pins (A) into the 5 holes as shown on
the leg frame and secure with a screwdriver.
Repeat for both leg frames.
3. Insert the dowel into the bottom hole of
the leg frame - repeat on the other leg
frame.
4. With one leg frame on its side with all the
ttings securely tightened - place facing up
on the oor.
5. Place the 4 x cam ttings (C) into the holes
on the back of the rear of the carcass and
also inside the front of the carcass. align
these so that the outer line on the cam is
facing towards the edge of the carcass.
6. With assistance lift the carcass onto the
leg frame and secure the cams by turning
the centre with a at head screwdriver.
Whilst one person is holding the leg frame
+ carcass place the cam (C) into rear
crossbar and secure in place.
7. Place the remaining 5 cams into the holes
in the carcass and align like before. Lower
the second leg frame into place and secure
all cam ttings until tight.
8. Making sure not to rest on the legs - turn
the dressint table fully over onto its feet.
Please take care that the drawer doesn’t
open whilst turning the dressing table onto
its feet.
9. Insert the two top covers and gently place
the mirror into the desired position along
the rear channel in the dressing table.
A x 10 B x 10 C x 2
A
B
C
Step 4.
Step 6.
Step 7.
Step 9.
Assembly Instructions