Case Cross User manual

Cross
Extending Table
Cross Extending Table – designed by Matthew Hilton
To prolong the life of the product and retain its appearance and functionality,
we would like to give you some relevant information and care advice:-
This unit is manufactured oak or walnut depending on the nish. The legs and
underframe are solid - the top and extension leaves are veneered for greater stability.
Skilled craftsmen manufacture this product and there is variety between each unit. This
is because wood is a natural product, with natural colour and grain variations.
Natural timber is affected by sunlight; this can can the wood colour to darken.
For this reason (especially if placed in direct sunlight) it is recommended that placing
objects in the same position for long periods of time is avoided. This potential colour
adjustment becomes less relevent as the product ages.
It is recommended that no abrasive cleaners or solvents are used to clean the unit.
Please only use proprietary furniture polishes or alternatively, warm water with
a diluted mild detergent.
We thank you for purchasing this product and wish you many years of enjoyable and
functional use.
For more related products please visit: casefurniture.com
Care Instructions
Case Furniture Ltd
London, SW18 2HZ
United Kingdom
[email protected]
casefurniture.com

Assembly Instructions
A x1
C x8
D x8
E x4
F x4
G x4
B x2
H x4
1. Unpack all components and allow
ample room for assembly and turning.
2. Attach bracket (B) to one leg using
bolts (C) and allen key (A) once fully
tightened attach second leg and repeat
for second set of legs. Ensure the
brackets are the correct way up.
(Fig. 1A + 1B)
3. Insert dowells (D) into the two holes
shown and repeat for each set of legs.
(Fig. 2)
4. Fasten all legs to the underframe using
long bolts (E) and medium bolts (F) and
allen key (A). FULLY TIGHTEN BOLTS.
(Fig. 3)
5. Slot the crossbar into the leg brackets
(B) and tighten using short bolt (G) and
Allen Key (A)
(Fig. 4)
6. Now tighten all leg and crossbar bolts.
The table can now be turned onto its feet.
THE TABLE IS EXTREMELY HEAVY. TAKE
EXTRA CARE WHEN TURNING AND DO
NOT LIFT BY THE TABLE TOP - USE THE
UNDERFRAME TO LIFT THE TABLE
7. After turning the table onto its feet
release the transit bolts on both ends of
the underside of the table and remove
the 3 packers at each end of the top.
(Fig. 5)
8. Open the top fully and insert the bolts (H)
into the holes inside the felt lined area at
both ends of the table.
Tighten fully with allen key (A)
(Fig. 6)
9. To extend the table and store leaves,
release the locking-tabs - accessed by the
holes on the underside of the centre of
the table. Pull tabs down to lock the top
in place.
(Fig. 7)
Store extension leaves
inside the table.
E
F
BG
D
D
CB
A
H
Fig. 1B
When inserting bolt (C)
use your thumb and nger
to tighten initially before
using Allan key (A).
Fig. 1A
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Fig. 7