Case Covet Installation guide

Covet
Desk
Care Instructions
Case Furniture Ltd
London, SW18 2HZ
United Kingdom
[email protected]
www.casefurniture.com
Covet Desk – designed by Shin Azumi
To prolong the life of the product and retain its appearance and functionality,
we would like to give you some relevant information and care advice:-
This unit is manufactured from solid oak or walnut.
Craftsmen manufacture this product and there is variety between each unit. This is
because wood is a natural product, with natural colour and grain variations.
Natural timber is affected by sunlight; this can can the wood colour to darken.
For this reason (especially if placed in direct sunlight) it is recommended that placing
objects in the same position for long periods of time is avoided. This potential colour
adjustment becomes less relevent as the product ages.
It is recommended that no abrasive cleaners or solvents are used to clean the unit.
Please only use proprietary furniture polishes or alternatively, warm water with
a diluted mild detergent.
Care should be taken when placing items onto the glass top; especially heavy items
that if dropped could cause the glss to shatter.
Two people should lift the glass in order to avoid damage.
Do not put excessive weight on the glass and never sit or stand on the desk.
We thank you for purchasing this product and wish you many years of enjoyable and
functional use.
For more related products please visit: casefurniture.com

Assembly Instructions
1
Required
Supplied
A x 4
B x 4
C x 4
Step 1. Attach all the cam pins (tting C) into the pre-tted threaded
inserts and tighten with a screwdriver, as shown in detail 1.
Step 2. Insert all dowels (tting A) into the remaining holes as shown in
detail 3.
Step 3. Place one of the leg sections on the oor with the ttings facing
upwards, place the cams (tting B) detail 2 into the relevant holes and
line up with the cam pins (tting C). Insert (Fitting D) into the large holes
on the cross rail and align the holes.
Step 4. Place the cross rail and then drawer section onto the leg and
tighten the top of the cams (tting B). Repeat process for the shelf sec-
tion and fully tighten (tting D).
Step 5. Place the remaining leg section onto the top end of the unit and
fully tighten the top of the cams (tting B).
Step 6. Carefully turn the desk onto its feet and insert the glass support
pads (tting F) into the cam holes as shown in detail 2.
Carefully lift and position the glass top in place.
F x 4
F
C
A
A
ED
B
D x 6
E x 6
C
A
A
2
3