Case Ballet Installation guide

Ballet
Table
Care Instructions
Case Furniture Ltd
London, SW18 2HZ
United Kingdom
[email protected]
casefurniture.com
Ballet Table – designed by Matthew Hilton
To prolong the life of the product and retain its appearance and functionality,
we would like to give you some relevant information and care advice:-
This unit is manufactured from solid oak.
Craftsmen manufacture this product and there is variety between each unit. This is
because wood is a natural product, with natural colour and grain variations.
Natural timber is affected by sunlight; this can can the wood colour to darken.
For this reason (especially if placed in direct sunlight) it is recommended that placing
objects in the same position for long periods of time is avoided. This potential colour
adjustment becomes less relevent as the product ages.
It is recommended that no abrasive cleaners or solvents are used to clean the unit.
Please only use proprietary furniture polishes or alternatively, warm water with
a diluted mild detergent.
We thank you for purchasing this product and wish you many years of enjoyable and
functional use.
For more related products please visit: casefurniture.com

Assembly Instructions
A x 8
B x 8
Required
Supplied
Step 1. Place the washers (tting B) on
the bolts (tting A) Place the Bolt and
washer into the holes on the rail as
shown. Move the leg into place and
align with the relevant holes. Ensure that
all bolts are properly located before
tightening with the supplied Alan key.
Step 2. Once all the bolts are tightened,
carefully turn the table over without
resting on the legs until fully turned.