Castleton Home ZH2023 User manual

For assistance with assembly contact:
Wayfair Customer Service,
877-WAYFAIR (877-929-3247)
www.wayfair.com
Page 1
ZH2023 Bench –Grey linen
ZH2023 Bench –Oatmeal linen
ZH2023 Bench –White linen
Assembly Instructions

A Quantity
of 1
Back panel
B Quantity
of 1
Seat
CQuantity
of 2
Front legs
DQuantity
of 1
Left back leg
EQuantity
of 1
Right back leg
1 Quantity
of 4
Screw Dia 8mm*1”L
2 Quantity
of 10
Bolt: Dia 5/16”* 2”L
3 Quantity
of 4
Bolt: Dia 5/16”* 2-1/2”L
4 Quantity
of 14
Spring washer
5Quantity
of 14
Flat washer
6Quantity
of 1
Allen wrench
Care and Cleaning Instructions:
Please see care and cleaning label attached to
bottom of chair seat.
For replacement parts or questions, please
call Customer Service at 877-WAYFAIR
(877-929-3247)
Page 2
ZH2023 Bench
Parts List
Before beginning assembly, separate all parts and carefully study the parts diagrams below.
Review all parts and hardware before disposing of any packaging.
You may receive extra hardware with your unit.
Call Customer Service for missing hardware.
Assembly Tool Required No.2 Phillips
Screwdriver (Not included)

.
Figure 1
Unpack and lay parts on clean,
padded surface like carpet or
blanket. Check that you have all
parts indicated on the front page.
Lift the Velcro strip from the
bottom of the seat (B) and take
out the leg box which includes 2
front legs and 2 back legs.
Open the legs box and take out
the legs.
Figure 2
Attach seat (Part B) to back (Part
A) by bolts (2), spring washers (4)
and flat washers (5). Don’t
tighten bolts until all bolts are in
place. Tighten bolts (2) by using
Allen wrench (6) as shown in
Figure 2.
Page 3
ZH2023 Bench
Assembly Instructions
A
B
2
4
5
6
2
4
5
B
Leg Box
Step 1
Step 2

Figure 3
Attach left back leg (part D) and
right back leg (part E) into the
seat (A)’s pre-drilled holes,
turning left back leg (part D)/right
back leg (part E) by hand as
shown in Figure 3.
Tighten left back leg (part
D)/right back leg (part E)’s by
Screw (1) with Phillips
screwdriver (not included) as
shown in figure 3.
Attach the front legs (Part C) to
the seat (A)’s pre-drilled holes.
Insert bolt (2), spring washers (4)
and flat washers (5) into
pre-drilled holes, tighten bolt (2)
by Allen wrench (6) as shown in
figure 3.
Figure 4
Close Velcro strip on the bottom of
seat (A).
Page 4
A
B
C
D
C
B
345
6
E
C
1
A
B
C
E
D
C

Figure 5
Turn over the bench,
Now your bench is ready to use!
Page 5