CB2 Facade User manual

facade BED - QUEEN
Made in USA - r07 Page 1 of 3
hardware
components
tools required
Thank you for purchasing the Facade Queen Bed.
This page lists all the contents included in the box.
Please take the time to identify the hardware as well as
the individual components to this product. As you
unpack and prepare for assembly, place the contents
on a carpeted or padded area to protect them from
damage.
Note: 2 people are required to safely assemble this product.
Missing hardware?
Please call 800.606.6387 for replacements.
2 - side rails
(1 left, 1 right)
13 - slats
1 - center
support
2 - center
support legs
39 - screws 2 - spacers
(We recommend the use of hand tools instead of power tools)
Customer Service 800.606.6252 | Latest instructions available at www.cb2.com
phillips head screwdriver
1 - headboard
1 - footboard

facade BED - QUEEN
Customer Service 800.606.6252 | Latest instructions available at www.cb2.com
Made in USA - r07 Page 2 of 3
1 2
34
With the assistance of another adult, lift both ends
of side rail so it is the same distance from the floor.
At this point, insert pegs of each side rail into
corresponding holes in each bracket of headboard
as shown. Push down firmly at each bracket until
it locks into position.
Attach brackets of left/right side rails into
corresponding brackets of footboard as shown.
Attach 2 slats to center support with 1 screw per
slat as shown. Secure, but do not over tighten,
screw with a phillips head screwdriver.
right side
rail
left side
rail
headboard
footboard
right side
rails
left side
rails
center
support
slat
Attach 2 center support legs to center support
assembly as shown. Turn each support leg
clockwise to secure.
center support
assembly
center
support
leg

CLEANING AND CARE
Fabric cleaning code S: to prevent overall soil, frequent vacuuming
or light brushing to remove dust and grime is recommended. 
Spot clean using a mild water-free solvent or dry cleaning product. 
Clean only in a well ventilated room and avoid any product
containing carbontetra-chloridewhich ishighlytoxic. 
Pretest small area before proceeding. 
Cleaning by a professional cleaning service is recommended.
Customer Service 800.606.6252 | Latest instructions available at www.cb2.com
Made in USA - r07 Page 3 of 3
5 6
Align slats so they are parallel to the headboard
and footboard. Secure assembly with 4 screws as
shown. Make sure center support is securely
supported by each support leg.
Attach remaining 11 slats to center support rail
with 3 screws per slat as shown. Before securing
each screw to side rails and center support, use
the spacer to determine spacing between slats as
shown.
Assembly is now complete.
spacer
facade BED - QUEEN