Chauvet Data Stream 4 User manual

User Manual

TABLE OF CONTENTS
1. Before you Begin ................................................................................................................ 3
What Is Included....................................................................................................................................3
Unpacking Instructions ..........................................................................................................................3
Claims............................................................................................................................................................ 3
Text Conventions...................................................................................................................................3
Symbols.................................................................................................................................................3
Disclaimer..............................................................................................................................................3
Product at a Glance...............................................................................................................................4
Safety Notes..........................................................................................................................................4
2. Introduction......................................................................................................................... 5
Product Overview ..................................................................................................................................5
Product Dimensions ..............................................................................................................................5
3. Setup.................................................................................................................................... 6
AC Power...............................................................................................................................................6
Fuse Replacement.................................................................................................................................6
Mounting................................................................................................................................................7
Orientation..................................................................................................................................................... 7
Rigging........................................................................................................................................................... 7
4. Operation............................................................................................................................. 8
Operating Instructions ...........................................................................................................................8
Setting up a DMX Serial Data Link........................................................................................................8
5. Appendix ............................................................................................................................. 9
General Maintenance ............................................................................................................................9
General Troubleshooting.......................................................................................................................9
6. Technical Information........................................................................................................10
Technical Specifications......................................................................................................................10
Returns ................................................................................................................................................11
Contact Us..............................................................................................................................12
Page 2 of 12 DataStream™ 4 User Manual Rev. 2

1.BEFORE YOU BEGIN
What Is
Included
•DataStream™ 4
•Power Cord •Warranty Card •Quick Reference Guide
Unpacking
Instructions
Carefully unpack the product immediately and check the container to make sure all the
parts are in the package and are in good condition.
Claims
If the box or the contents (the product and included accessories) appear damaged from
shipping, or show signs of mishandling, notify the carrier immediately, not Chauvet
Failure to report damage to the carrier immediately may invalidate your claim. In
addition, keep the box and contents for inspection.
For other issues, such as missing components or parts, damage not related to shipping,
or concealed damage, file a claim with Chauvet within 7 days of delivery.
Text
Conventions
Convention Meaning
1–512
A range of values
50/60
A set of values of which only one can be chosen
Settings
A menu option not to be modified
Menu > Settings
A sequence of menu options to be followed
<ENTER>
A key to be pressed on the product’s control panel
ON
A value to be entered or selected
Symbols Symbol Meaning
Critical installation, configuration, or operation information. Not
following these instructions may make the product not work, cause
damage to the product, or cause harm to the operator.
Important installation or configuration information. The product
may not function correctly if this information is not used.
Useful information.
Disclaimer
The information and specifications contained in this document are subject to change
without notice. Chauvet
assumes no responsibility or liability for any errors or omissions
that may appear in this manual. Chauvet reserves the right to update the existing
document or to create a new document to correct any errors or omissions.
You can download the latest version of this document from www.chauvetlighting.com.
© Copyright 2015 Chauvet. All rights reserved
Electronically published by Chauvet in the United States of America
Author Date Editor Date
M. Trouard 06/30/2015 A. Leon 06/30/15
DataStream™ 4 User Manual Rev. 2 Page 3 of 12

Product at a
Glance
Use on Dimmer
x
Auto Programs
x
Outdoor Use
x
Power Cord
P
Sound-Activated
x
Replaceable Fuse
P
DMX
P
User-Serviceable
x
Master/Slave
P
Duty Cycle
x
Safety Notes Please read the following Safety Notes carefully before working with this product
. They
include important safety information about its installation, usage, and maintenance.
•Always connect this product to a grounded circuit to avoid the risk of electrocution.
•Make sure the power cord is not crimped or damaged.
•Never disconnect this product from power cord by pulling or tugging on the cord.
•If mounting this product overhead, always secure it to a fastening device using a
safety cable.
•
Make sure there are no flammable materials close to the unit while operating.
•Always make sure that the voltage of the outlet to which you are connecting this
product is within the range stated on the decal or rear panel of the product.
•This product is for indoor use only! (IP20) To prevent risk of fire or shock, do not
expose this product to rain or moisture.
•Never connect this product to a dimmer.
•Never carry this product from the power cord or any moving part.
•The maximum ambient temperature is 104 °F (40 °C). Do not operate this product at
higher temperatures.
•In the event of a serious operating problem, stop using the unit immediately.
•Never try to repair this product. Repairs carried out by unskilled people can lead to
damage or malfunction. Please contact the nearest authorized technical assistance
center.
•To eliminate unnecessary wear and improve its lifespan, during periods of non-use
completely disconnect the product from power via the breaker or by unplugging it.
•Keep this User Manual for future consultation. If you sell this product to another user,
be sure that they also receive this document.
Page 4 of 12 DataStream™ 4 User Manual Rev. 2

2.INTRODUCTION
Product Overview
Product Dimensions
Front View
Back View
DMX Outputs
DMX In
3 & 5 Pin
Power In
5.3 in
134 mm
19 in
483 mm
1.8 in
46 mm
Fuse Holder
M8 Threaded
Insert
DMX Link
Out/Throughput
LED In Use
Indicators
LED ON
Indicator
Ears for
Rackmount
DMX Signal
Indicator
DataStream™ 4 User Manual Rev. 2 Page 5 of 12

3.SETUP
AC Power This product has an auto-ranging power supply and it can work with an input voltage of
100 to 240 VAC, 50/60 Hz.
To determine the power requirements for this product (power outlet and wiring), use the
current value listed on the label affixed to the product
’s back panel, or refer to the
product’s specifications chart. The listed current rating indicates the product
’s average
current draw under normal conditions.
•
Always connect this product to a protected circuit (circuit breaker or fuse),
making sure that it has an appropriate electrical ground to avoid the risk of
electrocution or fire.
•To eliminate wear and improve its lifespan, during periods of non-use
completely disconnect from power via breaker or by unplugging it.
Never connect this product
to a rheostat (variable resistor) or dimmer circuit,
even if the rheostat or dimmer channel serves only as a 0 to 100% switch.
Fuse
Replacement 1. Wedge the tip of a flat-head screwdriver into the slot of the fuse holder.
2. Pry the fuse holder out of the housing.
3. Remove the blown fuse from the holder and replace with a fuse of the exact same
type and rating.
4. Insert the fuse holder back in place and reconnect power.
Disconnect the product from the power outlet before replacing the fuse.
Installed fuse
(held by plastic clip)
Spare fuse holder
(inside safety cap)
Safety cap
Page 6 of 12 DataStream™ 4 User Manual Rev. 2

Mounting
Before mounting this product, read and follow the Safety Notes.
Orientation The DataStream™ 4
may be mounted in any position; however, make sure adequate
ventilation is provided around the product.
Rigging Before deciding on a location for this product
, always make sure that it will be easy to
access the unit for maintenance and programming purposes.
Make sure that the structure onto which you are mounting this product
can support its
weight. See the Technical Specifications for weight information.
When mounting this product overhead, always use a safety cable. Mount the product
securely to a rigging point, whether an elevated platform or a truss.
When rigging this product onto a truss, you should use a mounting clamp of appropriate
weight capacity.
The product has an M8 threaded insert mounting hole located on the back of the unit for
easy truss mounting. There are also two ears for rack mounting. This product uses 1U of
space.
Mounting Diagram
Threaded Insert
Rack
Mounting
Holes
DataStream™ 4 User Manual Rev. 2 Page 7 of 12

4.OPERATION
Operating
Instructions This is a DMX splitter, and it is designed to distribute /
boost the incoming DMX signal
into 4 separate
outputs. Each of the 4 outputs is electronically isolated from the others
(with the exception of the “thru” or “link” output) and each output has 3- and 5-
pin XLR
sockets to choose from.
Follow all DMX standards when using this device.
Setting up a
DMX Serial
Data Link
1. Connect the (male) 3 / 5 pin connector side of the DMX cable to the output (female)
3 / 5 pin connector of the controller.
2.
Connect the end of the cable coming from the controller which will have a (female)
3 / 5 pin connector to the input connector of the next fixture consisting o
f a (male)
3 / 5 pin connector.
3.
Then, proceed to connect from the output as stated above to the input of the
following fixture and so on.
Fixtures
DMX OUT
4-Way
Splitter
DMX LINK OUT
Throughput
DMX In
Page 8 of 12 DataStream™ 4 User Manual Rev. 2

5.APPENDIX
General Maintenance
To maintain optimum performance and minimize wear fixtures should be cleaned frequently. Usage and environment are
contributing factors in determining frequency. As a general rule, fixtures should be cleaned at least twice a month. Dust build
up reduces performance and can cause overheating. This can lead to reduced life and increased mechanical wear. Be sure to
power off the fixture before conducting maintenance.
Unplug fixture from power. Use a vacuum or air compressor and a soft brush to remove dust collected on external vents and
internal components.
Cleaning frequency depends on the environment in which the fixture operates: damp, smoky or particularly dirty surroundings
can cause greater accumulation of dirt on the unit. Clean with soft cloth using normal glass cleaning fluid. - Always dry the
parts carefully.
General Troubleshooting
Symptom
Possible Solution(s)
Device has no power
Check for power on Mains
Check device's fuse, replace if necessary
No Signal Output, Signal Indicator Not Flashing
Check Input Source
No Signal Output, Signal Indicator is Flashing
Contact Chauvet Technical Support
If you still have a problem after trying the above solutions, please contact Chauvet Technical Support from the
Contact Us page.
DataStream™ 4 User Manual Rev. 2 Page 9 of 12

6.TECHNICAL INFORMATION
Technical Specifications
Dimensions and
Weight
Length
Width
Height
Weight
19 in (483 mm)
5.3 in (134 mm)
1.6 in (46 mm)
5.8 lb (2.6 kg)
Note: Dimensions in inches rounded to the nearest decimal digit.
Rackmount Size
1U
Power
Power Supply Type
Range
Voltage Selection
Switching (Internal)
100 to 240 VAC, 50/60 Hz
Auto-ranging
Parameter
120 V, 60 Hz
240 V, 50 Hz
Consumption
3 W
5 W
Operating current
0.01 A 0.01 A
Fuse
1 A, 250 V 1 A, 250 V
Thermal
Maximum External Temp.
Cooling System
104 °F (40 °C)
Convection
DMX
I/O Connectors
Connector Type
3-Pin & 5-Pin XLR
Socket
Ordering
Product Name
Item Code
UPC Number
DATASTREAM4
09080128
781462202828
Page 10 of 12 DataStream™ 4 User Manual Rev. 2

To return a product or request support:
•If you live in the U.S., contact Chauvet World Headquarters (see Contact Us).
•If you live in the UK or Ireland, contact Chauvet Europe Ltd.(see Contact Us).
•If you live in Mexico, contact Chauvet Mexico (see Contact Us).
•If you live in Benelux, contact Chauvet Europe BVBA (see Contact Us).
•If you live in any other country, DO NOT contact Chauvet. Instead, contact your
distributor of record. Refer to our Web site for contact details of distributors outside
the US, United Kingdom, or Ireland.
If you live outside the U.S., United Kingdom, Ireland, Mexico, or Benelux contact
your distributor of record and follow their instructions on how to return Chauvet
products to them. Visit our Web site for contact details.
Returns
Call the corresponding Chauvet
Tech Support office and request a Return Merchandise
Authorization (RMA) number before shipping the product
. Be prepared to provide the
model number, serial number, and a brief description of the cause for the return.
You must send the merchandise prepaid, in its original box, and with its original packing
and accessories. Chauvet will not issue call tags.
Clearly label the package with the RMA number. Chauvet will refuse any product
returned without an RMA number.
DO NOT write the RMA number directly on the box. Instead, write it on a properly
affixed label.
Before sending the product, clearly write
the following information on a piece of paper
and place it inside the box:
•Your name
•Your address
•Your phone number
•RMA number
•A brief description of the problem
Be sure to pack the product
properly. Any shipping damage resulting from inadequate
packaging will be your responsibility. FedEx packing or double-
boxing are
recommended.
Chauvet
reserves the right to use its own discretion to repair or replace returned
product(s).
DataStream™ 4 User Manual Rev. 2 Page 11 of 12

C
ONTACT
U
S
WORLD HEADQUARTERS - Chauvet
General Information
Address: 5200 NW 108th Avenue
Sunrise, FL 33351
Voice: [phone]
Fax: [phone]
Toll free: [phone]
Technical Support
Voice: [phone] (Press 4)
Fax: [phone]
Email: tec[email protected]
World Wide Web www.chauvetlighting.com
UNITED KINGDOM AND IRELAND - Chauvet Europe Ltd.
General Information
Address: Unit 1C
Brookhill Road Industrial
Estate
Pinxton, Nottingham, UK
NG16 6NT
Voice: [phone]
Fax: [phone]
Technical Support
Email: ukt[email protected]om
World Wide Web www.chauvetlighting.co.uk
MEXICO - Chauvet Mexico
General Information
Address: Av. Santa Ana 30
Parque Industrial Lerma
Lerma, Mexico C.P. 52000
Voice: [phone]
Technical Support
Email: servic[email protected]
World Wide Web www.chauvet.com.mx
CHAUVET EUROPE - Chauvet Europe BVBA
General Information
Address:Stokstraat 18
9770 Kruishoutem
Belgium
Voice: [phone]
Technical Support
Email: [e-mail]
World Wide Web www.chauvetlighting.eu
Outside the U.S., United Kingdom, Ireland, Mexico, or Benelux
contact your dealer. Follow their
instructions to request support or to return a product. Visit our website for contact details.
Page 12 of 12 DataStream™ 4 User Manual Rev. 2