CHC i80 GNSS Operator's manual

CHC® i80 GNSS Receiver
Quick Tour of NFC

i80 GNSS Receiver Quick Tour of NFC
1
1.Prerequisites
Hardware: Android Device with NFC
Software: Landstar7 or 3rd party software
2. Introduction of NFC
Near field communication (NFC) is a set
of communication protocols that enable two
electronic device, one of which is usually a
portable device such as a smartphone, to
establish communication by bringing them
within 4 cm (2 in) of each other.
3. Location of NFC Chip
3.1 NFC in i80
At the left side of roof cover, there is an
icon of NFC, please refer to following
picture:
3.2 NFC in HCE300
At the back cover above SN/PN label,
there is an icon of chip with hand,
please refer to following picture:
Tips: For the location of NFC in other
device, please refer to the instruction of
manufacturer.
4. Connection via NFC
- Bring i80 and HCE300/other devices within
4cm (2 in) of each other.
After a beep, the connection is established,
check the screen of HCE300. Landstar 7 will
run automatically.
- Connect with device: Bluetooth/WIFI
- After connection, Go to NFC/WIFI. It will
prompt to keep controller close to receiver
NFC label until getting NFC message.

i80 GNSS Receiver Quick Tour of NFC
2
- After getting NFC message, it will be stored.
- Next time, when controller and i80 are
connected via NFC, Landstar7 will
automatically run and connect with this i80.
Tips: For other device with NFC function, users
need to select the software to run if there are
several NFC supported software